Farmall M ammeter randomly spiking

[706man]

The belt seems pretty tight. Every time the hood is off I try to tighten it.

Right now, using drawing 5 that was posted here today, the system seems to be working. Other than the original problem of the ammeter pegging at 30. With the tractor off the battery is 13.7 volts and with it running is bounces around at 17, 18 and 19 volts. Is that good enough to say the alternator is working? If so, I am guessing I don't run the tractor enough to charge battery.
Thanks for the pictures and the guidance.
Now that it is most likely wired correctly I can order the new components and swap them out. Then wire the lights up.

 

[used red MN]

With the tractor off the battery is 13.7 volts and with it running is bounces around at 17, 18 and 19 volts.

What kind of meter are you using? The static voltage of a fully charged 12 volt battery is 12.7 volts. If you checked it right after you ran it and it was actually showing voltages between 17-19 volts it might be understandable because the voltage in the battery would be dropping to stabilize. The voltage on an alternator that working correctly should never go over 14.5 volts. Do you still have the points ignition on this tractor? If so the and you have a cheap digital meter the “electrical noise” from the points may be making it give erroneous readings. What does the ammeter do after running it 5 minutes at half throttle? If the battery had a sufficient charge to start the tractor unassisted it should show a higher charge for the first several minutes and then drop back once the charge in the battery builds. If it continually shows a high charge rate I would take the alternator to be tested and tell whoever is testing it you suspect it is over charging.

 

[Jim.ME]

Indications are the alternator is working; the internal regulator might be acting up.

The alternator is likely capable of 63 amps output, that was a common output so you should have a 60-0-60 range ammeter not a 30.

 

[706man]

I do still have the points in there. And was using a multimeter from my father in law who is an electrician. Had it set on 12v. I used the tractor today for a half hour doing some chores and all seemed fine. I will get the alt tested.

 

[used red MN]

I do still have the points in there. And was using a multimeter from my father in law who is an electrician. Had it set on 12v. I used the tractor today for a half hour doing some chores and all seemed fine. I will get the alt tested.

If it doesn’t seem to over charge per the ammeter all is probably good. If it does show 17-19 volts on the battery that is questionable. If the meter is a Fluke brand it should be good, otherwise it would be interesting to know if the one he loaned you was just a cheap knock around.

 

[Brownie450]

Believe I'd put a 40 Amp breaker on the L terminal of the meter
& then put all load wires on the remaining breaker terminal. Just
a little extra insurance.
Jim