Pumpkin Steve
Member
I have a well house out back and took the cover off today to check the heater. Noticed the pressure gauge was pegged but the well was cycling and working ok so I figured bad gauge. Put a new one on and the cut-in and cut-out pressures were way low. Didn't kick on until a little less than thirty, and cut off at 55lb. Thought maybe it was set for 30-50 but I'm "sure" I've always used 40-60. I have a bladder type air tank, and it was a little low on pressure: 34 lbs so I pumped it up to 38. And there was a note I put on there back in 2018 that I had set the tank pressure to 38, so that reinforces my thinking that it is supposed to be a 40-60 system. Anyway I reset the pressure switch to 40-60 but it sure took a lot of adjustment. I would have thought just a few flats of the adjusting nuts would have been sufficient but I had to turn them a lot. Everything is working okay, kicking on and off where I want it but here's my concern: There is a spigot right there on that I open up to drop the pressure, and pump kicks on at about 40lb or maybe a little less. Pressure doesn't change much, apparently that's maxing out the pump, but then after a minute the pressure drops rapidly to 25 lbs. When I close the spigot it jumps back up to 38-40 and then climbs normally.
What is causing that? And why did it take so much adjustment to get the pressures right?
What is causing that? And why did it take so much adjustment to get the pressures right?