(800) 853-2651
SHOP NOW

Recent content by 4on-the-floor

Yesterday's Tractor Forums
  1. 4

    Power steering fluid

    This post was edited by 4on-the-floor on 07/13/2023 at 11:42 am.
  2. 4

    First year/model first Multi Power was available

    ----I remember my boss on a farm bought -2 MF 35 diesel engine in 1962 and he said they were the first ones of that series that had the Multi Power . I know we really liked them more than the old - TO- 35 gas engine with standard transmission we had been using .
  3. 4

    Engine Back fire

    New engine would be nice but since i am 79 years old and only use it to cut weeds , clean snow off the drive way and use the loader to lift and move things around . So for me it would be a poor investment . If it quits me and i can't take care of my country property i will probably sell out and...
  4. 4

    Engine Back fire

    Thanks to all I got it going now , just needed a little tune up . Drove 2 miles to the NAPA store . Got new spark plugs , Distributor cap , points , condenser , rotor , fuel filter . Runs real good now and probably will until no. one cylinder gets oil but that will be about October probably . I...
  5. 4

    Engine Back fire

    No it was just missing more than normal and i always drop it to idle when i shut it off and it never died on it's own . Just a loud pop out the exhaust after it was off . I don't know how hot the D23 plugs are but the ones they bring out to me that are supposed to be correct just won't last any...
  6. 4

    Engine Back fire

    Tractor not running smooth , cleaned plugs and set the gap . Ran lots better for about half an hour then started missing again . Shut engine off and after it quit running there was a loud pop like a back fire though the muffler . It's 1959 TO - 35 with the ---ZB - 134 Continental gas engine ...
  7. 4

    Power steering on FE 35

    I have a TO 35 with the 4 cy gas engine and here is how the pump is mounted . All the hydo is in the steering gear and no cylinders on the tie rods .
  8. 4

    TO35 Dashlight?

    I replaced all the gauges in my 1959 TO - 35 and the new ones all had lights in them accept the tractormeter . The old ones never had any lighting .
  9. 4

    TO 35 With Davis 102 Loader

    I have the Ferguson loader on mine and i think it's about like yours . I never got the front pump with it when i bought it so i have a " Prince " P.T.O. mounted pump . Installed the tank above it and did use a quick disconnect on the 1 1/4 hose and all the others . By doing it that way i can...
  10. 4

    TO35 Tractormeter Drive Take-off Assembly

    You can get an alt. with a tractometer [ tach ] cable hook up on the back of it . I can't remember tonight who has them , just do an internet search you should come up with one some place . I got the new tractormeter [ tach ] for mine and am going to just get my generator rebuilt . Or I can...
  11. 4

    Manifold to-35

    I removed mine but i don't remember what i used but they were hard to get out . The bad thing was the new one was harder to put back on . I may have used some metric and i think i ground the out side of the wrench and socket i used to get the clearance . I'm sure some others on here might know...
  12. 4

    fergie license plates

    Are those plates for just show or do you have to register tractors in MO. with plates ? We don't have such a thing in Idaho . JIM
  13. 4

    volt meter wiring

    Great , I knew how to correctly take care of the existing amp wire just was not sure of where to connect the positive wire on the volt meter, thanks . JIM
  14. 4

    volt meter wiring

    I tried using the search for information but never found any i could use . I am replacing all my gauges in a TO-35 with the continental gas engine. I want to replace the amp gauge with a volt meter. How do i wire it in ? I know it's different than an amp gauge. It's a 1959 model , 12 volt...
  15. 4

    number i cylinder ?

    I'm use to working on American inline 6 , v-6 and v-8 , all in front . I was not sure since the Ferguson was not American made as far as i know. Thanks JIM
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top