Recent content by 725Gunner

  1. 1961 Ford 801
    Sold

    For sale 1961 Ford 801

    ** MAKE AN OFFER** I just want it to go to someone who can get it running and use it. I don't want it to go to scrap, but I will need it gone. I have a Ford 801 tractor for sale, believed to be a 1961 but I am not certain. It has the 4 cylinder gas engine, select o speed transmission, P.T.O...
    $1,234.00
  2. 7

    No start on 801

    Do you have a diagram of the firing order so I can verify if I have it right?
  3. 7

    No start on 801

    Yes it was definitely a bright spark, had no problem jumping to the engine block.
  4. 7

    No start on 801

    Tested as you said and did not start. I went with a spark plug right off the coil and the spark was definitely present. Besides a faulty electronic ignition, what should I look at in the distributor?
  5. 7

    No start on 801

    Sorry for the delay. If I remove the red wire it will no longer crank. When I put the yellow wire to the battery It doesn't start. The battery is fully charged. I am getting a good 3.5 ohms in between the pos and neg on the coil.
  6. 7

    No start on 801

    I guess I'm not sure what that might be. I've bought all the parts from this site.
  7. 7

    No start on 801

    It was removed, because it all had to be replaced anyway. Since it isn't on wheels didn't put a new one in.
  8. 7

    No start on 801

    multimeter and spark plug tester
  9. 7

    No start on 801

    Doesn't even start, only cranks like it wants to.
  10. 7

    No start on 801

    I don't have a test light. There is power at the plus side of the coil in the run position.
  11. 7

    No start on 801

    Will check tomorrow and let you know
  12. 7

    No start on 801

    It cranks, but I can't get a spark. As far as the solenoid I couldn't say, it's the one that was on the tractor when I bought it. And it ran when I bought it.
  13. 7

    No start on 801

    Hoping someone can tell me if anything looks wrong on this setup, so I can figure out why I am not getting a spark. I get the starter to crank, and the engine turns, there just isn't spark. It is converted to 12V and the points and condenser were replaced with an electronic ignition. Has new...
  14. 7

    No start on 801

    What am I looking for to see they are opening and closing?
  15. 7

    No start on 801

    I have a 801 on 12v that I've been getting back into working order after my wiring harness burned up. All the wiring is replaced and the coil is new as well. I can't however get it to start now. The starter cranks and everything wants to turn. I checked today and I am not getting any spark. I...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top