(800) 853-2651
SHOP NOW

Recent content by 806Jr

Yesterday's Tractor Forums
  1. 8

    American Harvester

    My father in law only lives 10 miles from the Johnson's. Very nice and down to earth guys. If anybody wants to see the first episodes you can go to CarbonTv. Com they are playing the series to.
  2. 8

    OT: pig house/barn

    There was just a older 24x80 Lester finisher barn in the local paper that the guy was giving away just to get rid of it and there is also a older 30x80 Lester finisher barn on my local craigslist for free. Both looked to be in decent shape. So I don't think there is a lot of value in the...
  3. 8

    harvesting 30 inch corn with 36 inch head

    We did it for a couple years and it worked ok. We ran the head a little higher to help it bend and we also drove the tractor a little slower.
  4. 8

    Braggin' time with pics!

    Looks good. Everybody is so fast to assume just because they are young that they can't handle. My 12 and 10 yr old boys can drive my tractors way better than my wife can and she grew up on a farm! I was put on a JD 60 at the age of six pulling the baler and hay rack and I did just fine.
  5. 8

    Manure spreader manufacture?

    The neighbor had one just like the one in the picture and his was a tandem axle. His was a Minneapolis Moline.
  6. 8

    IH 140 decals

    Hey guys, we are repainting a 1964 IH 140 and have some questions about decals for it. It had been poorly repainted before we got it so we aren't sure the decals that were on it were the correct ones for the year. It had the gold trimmed decals on it but we have found chrome trimmed decals and...
  7. 8

    806 pto issue

    Check your splines on the IPTO shaft, this is the hollow shaft that has the smaller shaft sticking out of it, the splines will wear thin and then will start to bend over. Also check the splines inside clutch pressure plate that the IPTO shaft slides into, they might be worn down to. It could be...
  8. 8

    2290 won't move

    Hey guys, I have a friend that has a 2290 that won't move in reverse or 1st and 2nd forward(doesn't matter what range the power shift is in)when it gets down below zero and the hydraulics won't work and the transmission oil light stays on, if you put it in 3 or 4th gear it will move. Now...
  9. 8

    Junkyard auction

    I was there to. I wasn't to happy about them selling the stuff in group lots, but was able to buy a couple of things from the scrappers after they bought the big bunches. A guy I know bought the Ford 901 sos, it runs like a top but the transmission slips when it warms up. He's going to use it...
  10. 8

    930 gelling up. Need help

    Thanks for all the replys, Jon f your right, the dang thing started acting up now that I'm down to a half a tank. I think I'll drain it and dump straight #1 in it for now as its sitting in the middle of the yard and when I get it started and in the shed I will look at putting a electric pump on...
  11. 8

    930 gelling up. Need help

    Hey guys, I have a 930 ck that keeps gelling up on me. I am running a 50/50 mix of #1 and #2 and anti gell additive. I have changed the fuel filters, put pipe insulation on as much of the fuel line from the tank to the filters that I could reach. I have a swather canvas wrapped completely around...
  12. 8

    I/we did a good job!

    I run a JD 96 pull type for my oats and I get a nice clean sample with it and didn't have really any regrowth of oats were I dropped the windrows of straw. We're as the bto's had thrown over so much that the regrowth were the straw windrows were looked like they actually had seeded them down! I...
  13. 8

    still using a 806

    I run a 806 diesel for my big tractor. 18.4-38" rubber and 3 point. My brother runs an 806 diesel as his big tractor to. Dad has 3-806 diesels and my brother in law has an 806 diesel to. If you can't tell we kinda like our 806's. Lol
  14. 8

    International 1066

    I hate to say it but could also be that the MCV pump is getting weak. My 806 did the same thing last fall, it had always worked fine and then it got cold and i went to move it and no brakes or steering and no go. Tryed removing the 5/8 plug and changed the filter and still nothing, got it in...
  15. 8

    Going rate for corn picking......

    The university of Minnesota web site says $27.65 an acre for ear corn picking.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top