(800) 853-2651
SHOP NOW

Recent content by AL.D

Yesterday's Tractor Forums
  1. A

    180 Allis Tow

    Can I tow a 180 Allis 4 miles home with no hydraulic pressure without hurting power director? Thanks AL
  2. A

    1655 Oliver diesel

    If it worked normal when you last used it there is a elbow that holds the relief valve on the internal lift cylinder that has been known to break off, and could cause your issue. Possibly moisture and cold combination. Good luck
  3. A

    Power beyond getting super hot.

    Is the triple valve for a open or closed hydraulic system?
  4. A

    white 2-88

    Does anybody know the torque for the small 5/16 head bolts? I have manual for 2-85 and 2-105 but earlier motors don't have those small bolts. Thanks for replies. AL
  5. A

    Need help, another 105 hydraulic problem

    The pto can leak when not in use. The cooler pump leak would be seal on the pump drive shaft. You have to remove hyd. pump,then four bolts hold cooler pump and drive shaft housing. You could look at agcopartsbooks.com for a picture. Be a tough job with cold hands at zero degrees. Good luck AL
  6. A

    2-85 power beyond ?

    Is there a way to put a power beyond type setup on a 2-85 to feed a loader valve? Thanks in advance. AL
  7. A

    1555--New Clutch, same problem

    Any chance somebody put clutch fork in backwards ?
  8. A

    2-85 white gear oil

    There is a vent/plug in back on top left corner of pto housing. Takes 80/90w Fill to upper plug level. AL.
  9. A

    Hydraulic question White 2-60

    Are you sure the hyd. couplings are compatible?
  10. A

    2-105 brakes,I need some help

    Those covers like too hang up on dowels at top and bottom. Spray them with lube,work on and off what you can. Air chisel works good if you have one that gets fat quick. Nothing holds but bolts and linkage. You will win eventually. AL
  11. A

    brake pedal stop pin

    Don't know what model your working on but i have taken a big hammer and punch and drove the piece on through the support.That was on a 2-70 and 1655, good luck AL
  12. A

    2-105 parking brake

    Take the small cover off brake housing, looks like dust cap on each side. In there is allen screw with lock nuts, with hand brake off loosen locknut turn allen screw in until snug then back off about 1/2 turn. Do on both sides.You want about three clicks on brake handle. Good luck with new toy! AL
  13. A

    2-85 hydraulic pump

    Wondering if anybody has had any luck good or bad with the aftermarket hydraulic pumps ? Need one for a 2-85 with the aluminum body.
  14. A

    1600 runs again

    If you at the parts book on line picture of that linkage, it is part reference # 14 that flips the wrong way! Good luck.
  15. A

    I Screwed Up Today!!!!

    Left hand drill bit might back it out if you can get to it.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top