(800) 853-2651
SHOP NOW

Recent content by Armando Ramirez

Yesterday's Tractor Forums
  1. A

    JD Z255 mower

    Thanks for the feedback. The mower has a Briggs and Stratton engine. I will check it out.
  2. A

    JD Z255 mower

    This is a 2014 mower. It has run good and it still is. However, lately, it's running good and then all of sudden, it changes into a smooth accelerating run. When it changes it still mows. I do not know what to check for. After a while, it changes back to a normal acceleration. Any ideas into...
  3. A

    8N overheating

    When I had the an Allis Chalmers, I had to run at high RPM to turn the shredder a little faster. It seems that this is not the case with a 8N. So it does not matter how fast the engine is going, the shredder will turn at a certain speed. Is this correct? Because I had the gas lever to the end...
  4. A

    8N overheating

    I just bought this 8N an it's overheating within a couple of hours or less. Where is the thermostat located? I would like to take it off. Any suggestions as to why it is overheating? I have not done anything to it but remove a clear view filter located next to the exhaust manifold. Your...
  5. A

    Ford 8N Gas line

    So, If I remove the filter, it won't stopped up the carb? I see some sediment on the glass repositor which is located under the tank. Let me know. Thanks.
  6. A

    Ford 8N Gas line

    So, If I remove the filter, it won't stopped up the carb? I see some sediment on the glass repositor which is located under the tank. Let me know. Thanks.
  7. A

    Ford 8N Gas line

    I see on the glass repository under the gas tank that it has some sediment. So, I remove the filter will it effect the carb? I appreciate your feedback. Let me know.
  8. A

    Ford 8N Gas line

    Thank you for all your responses. I will get rid of the filter and rubber hose which is next to the exhaust manifold. Good point.
  9. A

    Oil Filter on 9N

    I recently bought an 8N and I changed the oil and oil filter. Sure enough it leak around the lid of the cannister. I came read the forum for this subject found the answer. I went to NAPA and bought a NAPA 1010 gold filter which has the seal. Believe me it worked. No more oil leaking from the...
  10. A

    Ford 8N Gas line

    I recently bought this Ford 8N and it runs good but while running it sometimes stalls. I check everything out wiring, etc.. I rode it yesterday and notice the reason it stalls. I can see where the gas to the clearview filter gets empty. I undid the clamp a little for the line coming from the...
  11. A

    CA won't move

    I have had it with this CA model. Last couple of weeks, I had a crash course on how to set the timing and magneto timing until it fired up. Now, I got it working and after a few hours of work, it suddenly stop. It does not move backward or forward. I tried to pull it with the truck to move it...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top