(800) 853-2651
SHOP NOW

Recent content by bdpuller

Yesterday's Tractor Forums
  1. B

    JD A Wheelbase

    Tell Mark it's 144 inches!! LOL!!
  2. B

    jd730 vs farmall m

    730 will just keep chuggin on when the farmall runs out of steam, if it"s true div 2 tractor.
  3. B

    RD450 transplant

    Sweet lookin ride! Thanks for the replies.
  4. B

    RD450 transplant

    Looking for opinions/suggestions on which tractor to use-460 or 560.
  5. B

    Devine TX pull

    Tri County Antiques Contact Keith @210-219-8065
  6. B

    Exhaust cover during transport

    The exhaust and intake valves on the same cylinder would have to both be open for air to circulate
  7. B

    Nordheim TX Antique Pull

    There wasn"t a pull on the 9th to be rescheduled. Only in March, and it was rained out but not rescheduled.
  8. B

    G engine knock

    Check the clutch driver or the crank end-play. Both will make you think something's very serious.
  9. B

    new engine break in

    I've been told by a former Deere mechanic that standard procedure after overhaul was to warm it up to operating temp on dyno and then shut it off(without cool-down) and walk away untill next day. He claims they never had any issues.
  10. B

    New Braunfels Texas Tractor Pull

    Can anybody relay any info on location of pull and best way to get there?
  11. B

    Future 560 puller project

    I really haven't searched too hard yet, but any directions on where to look to find one of the RD motors?
  12. B

    Future 560 puller project

    Guess I shouldn't have stated if as Div III or IV. Pulling regs aren't that tight around here yet. It would be mostly for fun anyway, but not any diffent than the MMs with 800 engines that pull around here. I just wanna go fast and spice things up.
  13. B

    Future 560 puller project

    Been contimplating building a 560 for Div. III or IV. I have access to a propane 560 and possibly a diesel. I would really like to repower with something like a RD450 or 501 (if I can get my hands on something) or the newer 466. On the diesel side, making a D466 fit would be really cool and...
  14. B

    Colorado County Fair Columbus, Texas

    What time do things crank up and what's the usual pulling order.
  15. B

    Another 5 inches of rain last night !

    Wish I could take about half that off your hands. Sure is dry in S. TX.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top