-
B
hydraulics
If you have an I&T manual on this tractor, It covers the lift adjustments very well and also the principles of how the whole system works. It's a little technical but if you follow the instuctions closely you can check all the settings on the lift while it is on the bench. Since yours developed...- Bill McCormick
- Post #1
- Forum: Ford 9N, 2N & 8N
-
B
Clutch Adjustment
I have a 1948 8N and have too much free play in my clutch pedal (difficult to shift into gear since the clutch is not fully disengaged). Per the I&T manual, I have adjusted the clevis rod as far as it will go but it apears that I have a LOT of wear in the brake cross shaft bushings and the...- Bill McCormick
- Thread
- Replies: 1
- Forum: Ford 9N, 2N & 8N
-
B
John Deere A hood removal
Thanks, Adam. Getting the steering shaft off was the big question. I figured that it might have something to do with the cover you mentioned but I wanted to ask around for sure. The grill and related covers are off this machine and are pretty much trashed. The hood is not too good either and the...- Bill McCormick
- Post #1
- Forum: John Deere
-
B
John Deere A hood removal
We have a John Deere A, aprox a 1950 model, I am curious about how best to remove the hood. This tractor has not run in about 30 years but it was running when it was parked and still turns over. It was parked due to bearing failure on a transmission shaft. I would like to get the hood off so I...- Bill McCormick
- Thread
- Replies: 2
- Forum: John Deere
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy