(800) 853-2651
SHOP NOW

Recent content by biltwell1224

Yesterday's Tractor Forums
  1. 2

    Farmall H Distibutor Problem

    Hello, I have a 1946 H with a vertical distributor. I am not getting any spark. The wire that goes from the distributor coil to the distributor is not getting any power when it is connected to the distributor, however if I disconnect it from the distributor the wire will read 6.14 volts at both...
  2. S

    wide front axle problem on farmall C

    Greetings to all. I'm new to the site and just as new to the classic tractor thing. I recently acquired a 1950 Farmall C and am in the process of trying to return it to it's former glory. The steering arm had been broken and welded so many times, I have opted to replace with a newly fabbed one...
  3. O

    Rake teeth why do the old last longer then new

    OK so I have this old IH rake I use. I just replaced 10 broken off teeth and noticed that most of the teeth I just replaced are one I have replaced in the last couple years. Most of the older teeth have been on it since I have had it so why don't the new teeth last when the old ones do
  4. W

    Can I Disassemble PTO from inside?

    This may sound weird, but I'll try to explain. My 80 has a bad seal on the internal side of the PTO shaft. I have the tractor split to fix some differential problems, and I have access to the rear of the PTO at the same time, including the PTO oil pump, so I was going to replace the seal. After...
  5. A

    wd mag

    is there a place I can buy gaskets and new screws for the Fairbanks morris mags?
  6. M

    185 Allis chalmers radiator

    Looking for a good used radiator for a 185 Allis Chalmers. Call 615-516-6170 or email
  7. A

    John Deere 6620 rubber bushings in chaffer/sieve

    What is the best way to install the rubber bushings in the moving/supporting parts of the chaffer and sieve in a John Deere 6620?? I have one bushing that I know is gone. I know there might be a trick or two that makes the job easier. Someone told me lubricating them with soap. Should they...
  8. D

    7710 Brakes - they've been hot

    Saturday I got around to pulling out the left side brakes on the 7710. Tractor looks pitiful without the fenders and rops/canopy. I've attached the pictures showing some "unauthorized heat-treating." Most of the brake discs weren't too bad. But one or two were pretty thin and you can see...
  9. T

    Need mechanic

    Does anyone know of someone who works on tractors in the Greensboro/Reidsville/Burlington, NC area? I need a new lower fan pulley put on. I"d like to do it myself but I don"t think I have the strength or tools to take off the front end.
  10. B

    R factory Cab

    Do you have pictures of the cabs and what are you asking for price.
  11. B

    American Classics-John Deere and Harley Davidson

    First ever John Deere and Harley Davidson Show on "Car" night Tuesday August 11th and "Bike Night at Motor" Thursday August 13th at the Harley Davidson Musuem in Milwaukee. Contact [email protected] for more information.
  12. B

    Re: Farmall FC, 1951

    I think my Dad was surprised by all the attention, but I think he enjoyed it as well. Thank you for the comments I will pass them along to him.
  13. B

    Farmall FC, 1951

    Mike, Great to hear about your FC. My father is restoring a SCFD. Hope to have it ready for Red Power in WI. It was built in the CIMA plant in France. I copied an in progress picture.
  14. B

    John Deere and Harley Davidson

    Are there any tractor guys that also collect Harley's?
  15. B

    420 Block?

    Hey Billy, Thank you for the lead. I am not a Dubuque guy, what is a "good" 420 block worth? Any idea?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top