-
B
'57 311 Ring Gear
Thanks for the tip! The starter has 10 teeth, so that told me which to look for and fortunately John Saeli carries it. It's on the way.- blueridgetim
- Post #3
- Forum: Case & David Brown
-
B
'57 311 Ring Gear
Can anyone give me the correct part number for a flywheel ring gear for a '57 311 gas tractor? Looks like my options are G11274 (124 tooth) and VT4524 (96 tooth). I tried to start the old girl the other day and she instantly made the worst clanging and knocking imaginable. Pulled the starter to...- blueridgetim
- Thread
- Replies: 3
- Forum: Case & David Brown
-
B
Case 311 timing pin
My new to me 311 is bogging down under load (going uphill) so I want to check the timing. The timing pin does not come out perpendicular to the flywheel. Is this normal, or did a previous owner likely bend it trying to turn the flywheel with a pry bar? New rotor, dist cap, spark plugs, carb...- blueridgetim
- Thread
- Replies: 2
- Forum: Case & David Brown
-
B
300 radiator interchange?
Just reporting back on this. I couldn't find a G13090 so ordered the G45177 for my '57 RN. The listed height on websites for the 45177 does not include the filler neck, so it's a little over an inch too tall. Everything else lines up exactly (width, depth, bolt spacing, top and bottom hoses...- blueridgetim
- Post #13
- Forum: Case & David Brown
-
B
Case 311 hydraulic conversion for remote cylinder
Joe, thank you very much. Very generous of you and, from what I've seen from you on countless threads, it's just how you roll. I will update if i can track the parts down.- blueridgetim
- Post #3
- Forum: Case & David Brown
-
B
Case 311 hydraulic conversion for remote cylinder
Newby here. I picked up a 1957 Case 311 RN that had been sitting for a while and was able to get it running thanks to all of the great information here, so first, a sincere thank you to everyone. To the issue at hand, this tractor has the Eagle Hitch and I would ideally like to add lines for a...- blueridgetim
- Thread
- Replies: 2
- Forum: Case & David Brown
-
B
300 radiator interchange?
Was there any resolution on this? I would love an update as to their possible interchangeability. I just got a 1957 Case 311 round nose; serial #6075249, and looking for a new radiator. (Is the McCord radiator I pulled off of it original?) Liker others, I am finding some options for the...- blueridgetim
- Post #12
- Forum: Case & David Brown
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy