(800) 853-2651
SHOP NOW

Recent content by bob old iron

Yesterday's Tractor Forums
  1. B

    F-350 6.0 Problem

    had a 03 f-350 6.0,,,it was doing about the same as you stated, i would let off pedal then floor it and release as power comes back,,,was told it could be EGR valve, around $160, in front up by thermostat, easy replace, or the IPC sensor,,,,was putting in atative from ford dealer to help lube...
  2. B

    OT-handicap scooter

    watch out for the speed cops...lol
  3. B

    what do ya think????

    try a scale house, scale the front tires, then the rears. should show how much weight is at each end on tires, figure where the middle point is that you want to determine when on scale....'like the big rigs do at the port of entry'.
  4. B

    more 6 volt

    not to start an uproar, my w-6 had a 6v in it. started fine, had a 8v sitting around, put in and starts same. has mag. genny shows 15>30 amps charging at half throttle. no problems.
  5. B

    Most Liked Tires

    if you don't need tires for farming, run turf tires on it. like riding in a car. round and smooth. if and when i need them on my TO-20, unless i find a good swap deal, that what i will run, i just show and parades.
  6. B

    Stainless muffler

    i would check with local muffler shop or speed shops to see what they have close look-a-like. i was thinking of getting a straight chrome stack or a turbo muffler for my w-6.
  7. B

    I just have to tell someone

    i think i/all know your feeling, wishing our grand/parents were here to see it now. congrats!
  8. B

    Just interested

    scotland's version of tractor pulling, lol
  9. B

    Tractor Pics

    well 2 out of 3 pic, not bad. we get the idea. lol. do what you want, my TO-20 has the down swept exhaust to the rear axles, looks nicer/
  10. B

    O/T My new ride

    not to far off on the sixes, early 50, 223cid
  11. B

    more

    club member is don bender, wounder if they know each other. i think his daughter lives up that way.
  12. B

    Has this ever happend to you?

    just the reasons why our little club just pulls for the fun. one memeber quit because we weren't pulling so he could show up every one else with his powerful tractor...bye-bye, we are here to enjoy ourself, i told him, go the the ntpa if you want ot get serious trophy/ribbions.
  13. B

    Hope it gets there................

    a least you can go to bed with a clear mind knowing that you did somthing for the ones that needed.... thoses who take/steal from the ones that help, will get their rewards in the end when they least expect it.
  14. B

    latest project

    on c-list den, co. there is a guy [in mounment hill area] that makes 3-point hitches for tractors, he makes them with/for 2-inch reciver hitches, ball-hitch, on top of almost triangle shape can put ball for g-neck app. you have a good idea there also.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top