Recent content by boberjagel

  1. B

    behlen power steering

    I purchased a behlen steering motor and distributor pump used. Previous owner stated it worked good. It came from an M and went on an H. It is poor in my opinion. Neighbor has one on an M and he says he barely considers it an assist. Says its poor just like mine. Another neighbor has one on a...
  2. B

    30 and 40 series syncro range tractors

    Does the transmission pump stop running in the 30 and 40 series syncro tractors like the 20 series when clutch pedal is depressed?
  3. B

    3020 syncro hydraulics

    Yep tractor is a late 72 serial number and Deere addressed the PTO concern by replacement of several parts and transmission supply pump... $ 18000 later all I got was no more loader chatter. Shop foreman said even with this bill he massaged a lot off. I tried for more but he was between a rock...
  4. B

    3020 syncro hydraulics

    So yes thanks to all here replying. My loader is a JD 148 so its double acting lift cylinders. And now that its been mentioned I also struggle hooking up my bush hog to the 3 point. By the time I get close to lining up to the quick hitch I run out of steering and 3 point lift and have to shift...
  5. B

    3020 syncro hydraulics

    Yes loader work loading manure and snow . We had Deere dealership overhaul transmission pump and flow test front pump and all is well. They suggested run a PTO pump for loader specific on the rear PTO but we want that open for mowers and snow blower. they say this is a very common complaint. I...
  6. B

    3020 syncro hydraulics

    Can I run a PTO hydraulic pump off of the front PTO and tee it into the supply line going to the main pump up front so that I can have live hydraulics at the SCV's with the clutch pedal pushed in.
  7. B

    Behlen power steering farmall M

    What oil should i use in behlen power steering unit on the farmall M
  8. B

    1972 John Deeres

    I often hear that the value is high and the market is hot for 1971/1972 John Deeres such as 4020,3020,4000. Just curious if there is more to the story except that they were the last of that series before the newer generation of tractors.
  9. B

    Farmall H valves

    Have H that hasn't ran in 10 years. Is there anything good I can put through the gas while running to restore the valves.
  10. B

    late 4020 SMV bracket

    Was there an actual JD bracket that held the SMV sign on late 4020's
  11. B

    Farmall H two leaks

    My son inherited an H and he said both the rear end gear lube and the belly pump oil leak out badly when he put oil in. Apparently, both were empty or near empty when he got it. So what do we start looking for and where to fix the leaks. Thank You !
  12. B

    Late G Question

    My late G has 12 volt pos ground. The generator, regulator , coil and starter all have plates that say 12 volt or are stamped 12 volts. My uncle put in a 6 volt battery and ran it for a couple years but always started hard and didnt charge. I didnt discover the 6 volt battery until he passed away.
  13. B

    F-20 versus 806

    So when I was very small maybe like 5 or 6 dad plowed with F-20 and 2-16's John Deere plow. So getting into the arithmetic class I stated that now the 806 has 100 horsepower. Thus it will pull 10 bottom plow based off of the F-20 performance. I received an A in school and F at the local IH...
  14. B

    WD9-MD Fuel Filters

    I simply get mine for the super MTA-D from the Case IH dealer. They have never failed to have them .
  15. B

    M Farmall Sheppard Diesel

    So an M became an H after converting to a sheppard diesel. Was there any way to crank up the injector pump on those to make up the difference. How about a turbo?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top