-
B
Nitrous
around here every single pull nitrous is illegal. on top of that its a good way to blow up a motor. just ask drag racers.- bp44
- Post #1
- Forum: Tractor Pulling
-
B
farmall h/350 puller
cams are usually a waste of money at that rpm. a different grind may actually be worse than stock- bp44
- Post #1
- Forum: Tractor Pulling
-
B
wc war time rear end
an allis wc? my 1997 buick lesabre is probably rarer than that- bp44
- Post #1
- Forum: Allis-Chalmers
-
B
Farmall m motor
call up Gary Baker from michigan. He can get you a set of clearanced m rods that will be much safer.- bp44
- Post #1
- Forum: Tractor Pulling
-
B
Stroking Da M Engine.
Regardless of the drama, welding stock rods is a bad idea. my dad talked to a welding shop owner who said cast iron rods do not weld very well and might break. The better choice is to do 7 inch stroke and find pistons that are the correct height. Then bush the rods to that piston pin size and...- bp44
- Post #1
- Forum: Tractor Pulling
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy