(800) 853-2651
SHOP NOW

Recent content by Bruck

Yesterday's Tractor Forums
  1. B

    Hydra Power Leak 1650 Gas

    Does the motor have to be taken out to get to the seal?
  2. B

    Hydra Power Leak 1650 Gas

    I have a 1650 gas with a bad hydra power leak. The oil is running out by the chain/sprocket (in front of the transmission input shaft). The leak is the worst right after I shut the motor off. Right after I shut the motor off, the fluid just runs out for about 30 seconds then subsides a bit...
  3. G

    Deere website???

    I went on the Deere website to dream and drool over new utility tractors. The 3000 and 4000 series tractors are not on the website.....Or am I not going to the right part of the website.?
  4. B

    1650 Oliver Gas

    Thanks. I forgot another question I had. When I took the carb off there was 2 identical gaskets beween the carb and intake. Not sure why there would be 2. Is one enough?
  5. B

    1650 Oliver Gas

    I'm in the process of replacing the exhaust and intake manifold gaskets on my 1650. I have the manifold off and had it machined. I have a new set of gaskets and also the gasket that goes between the carb and the intake. My questions, is there a certain pound of torc I should tighten up the...
  6. B

    1650 Oliver Gas

    Are there any gaskets to replace?
  7. B

    1650 Oliver Gas

    I have a 1650 Oliver with a crack in the manifold. Is the manifold easy to take off? Any suggestions or pointers on how to do this? Is there any videos or instructions out there? Also, is there anything else that would make sense to do or replace while I have it off?
  8. B

    Oliver 1650 Lights

    I have single headlights in the front, one in the back and a tail light in the back. After rearraging a few wires last night I have it working properly (which is all 3 flood lights turning on in the first position and in the second position the back flood light goes off and the tail light goes...
  9. B

    Oliver 1650 Lights

    I've never had working lights on my 1650 I've had for a year or so. Luckily after looking at it over the weekend I got them to work (I think). The fuse was bad so I replaced it with a new 20 AMP fuse. Now, when I turn the switch to the first position, the two flood lights (front and back) on...
  10. B

    Oil Leak at base of gear shifter

    Thanks for the info. I'm thinking this may be happening as I'm always added hydraulic oil and have never had to add rear end oil. It is always running out of the check plug. What causes this and how is it fixed (or do I even want to know?).
  11. B

    Oil Leak at base of gear shifter

    Thanks. How/Where do I check the oil level?
  12. B

    Oil Leak at base of gear shifter

    Thanks for the reply. Maybe it is as simple as putting a new boot on. I thought I had bigger issues with a seal out or something else major. I wasn't aware how it worked. thanks again. I just need to find a boot somewhere.
  13. B

    Oil Leak at base of gear shifter

    I have an oil leak at the base of my gear shifter on my 1650 gas oliver. It just starting leaking the other day. It is not a bad leak but I notice it was wet around the boot. Any ideas what could cause this and how can it be fixed. It was aweful cold out when this happened. Not sure if...
  14. B

    1650 Oliver Oil Leak

    My 1650 gas oliver is leaking oil right at the front main crank shaft pulley. I was wondering if this is pretty common in the 1650 model and what is all involved in fixing this. Is this something that is very difficult and would I be better off taking it somewhere and having it done or can a...
  15. B

    Oliver 1650 Stumbles

    This message is a reply to an archived post by Adam WI on March 27, 2009 at 06:47:41. The original subject was "Oliver 1650 Stumbles". Did either of these suggestions do the trick for you? My 1650 does the exact same thing and has been for over a year. It runs just fine once I start it back...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top