(800) 853-2651
SHOP NOW

Recent content by Buddy Cook

Yesterday's Tractor Forums
  1. B

    Rebuilding 800 Ford distributor

    Thanks Bob that answers my question.
  2. B

    Rebuilding 800 Ford distributor

    The distributor on my 800 Ford broke one of the distributor weight spring strips. I have looked everywhere for a new weight and spring set but can not find any for the 600 - 4000. Found one for an 8N that looks the same but wanted to see if anyone has used the 8N weight set up before on the...
  3. B

    800 Timing

    Thanks for the help. I was worried that I might of got the flywheel on wrong but the book says it only goes on one way. I have cleaned on the flywheel but just can"t find any marks. I will work my way around it and hope they are on there somewhere.
  4. B

    800 Timing

    I bought a 57 800 gas and have been restoring it the last couple of years. Finishing bolting everything up and reading how to time it in the manual. The book says there are timing marks on the flywheel that you can see through the timing hole but I can not find any. Brought #1 up on top dead...
  5. B

    Ford 800 Transmission

    I am rebuilding my 57 Ford 800 with a 5 speed trans. and two stage clutch. I have the engine off and getting ready to replace the front transmission seal. When you grab the input shaft there is as least a quarter inch of play from side to side. Just checking to see if anyone knows if this is...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top