Recent content by Cardigan99

  1. A

    roster comb plow

    neighbor has a 2 14 roster comb plow points look likes they have never hit a rock before wants $75 need tires are these a very good plow they are green and white type has throw away point type plow
  2. C

    Key switch.

    After chasing a non existent spark for a week I broke down and bought a new wiring harness, cap, coil and key switch. Put the key switch in this morning and she fired right up. Merry Christmas.
  3. C

    ballast resistor?

    Is it possible I've got a bad starter button or key assembly?
  4. C

    ballast resistor?

    JMOR, more specifically, inside the distibutor housing there is a copper strip that attaches to the points at the same logation as the condenser. the other end of this is a post that goes through the dist housing and connects to the coil.
  5. C

    ballast resistor?

    Ok, quick history. starts (started) like a champ until the weather got cold. I don't think the engine completed 1 full cycle before firing under full choke. Cold weather comes and she doesn't want to start (same procedure, turn the key, pull the choke.. no start. push the choke in.. no start...
  6. C

    ballast resistor?

    Yikes!. New coil. new points and condenser and still no spark. Dell, wires are bright and tight. I did break the copper strip between the coil and points but replaced with the strip from the old points. Dbl checked the timing .. rotor pointing to head bolt at #1 TDC. Before replacing points etc...
  7. C

    ballast resistor?

    51 8N side mount. No spark. looking for my ballast resistor but it doesn't look like I have one. Should be right under my ammeter on the firewall I'm told but all I have there is a small terminal block with two posts maybe an inch and a half wide by 3/4 tall. Ignition to both sides, ammeter to...
  8. C

    12 volt conversion

    Thanks for the info guys. I think I'm going to stay with the 6 volt system for now (or for as long as my patience holds out). I've got a resistor question, but i'll start another post. Thanks again
  9. C

    12 volt conversion

    Thanks Bruce. I've read this before and the first page talked me out of the conversion. Let's face it, if the 6v system is working properly, why bother? Of course it's winter now and the N is giving me problems again (ran fine until it got down into the teens)and I don't feel like rolling around...
  10. C

    12 volt conversion

    Thinking of converting my 51 8n side mount to a 12 volt setup. Does anyone know if the alternator will clear the arm on a wagner loader?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top