(800) 853-2651
SHOP NOW

Recent content by caserupman

Yesterday's Tractor Forums
  1. C

    Massey 35

    I?m not sure previous owner said it started when he was bush hogging. I haven?t owned it that long. Runs fine. But when you put it in gear and go to pull of it starts knocking real loud as your let the clutch up.
  2. C

    Massey 35

    I have a 65 Massey 35 diesel 2 stage clutch. When I go to put it in gear and I let out the clutch I get a loud knocking noise in the clutch housing area? Can anyone tell me what this might be and how to fix it.
  3. C

    Case 310 utility question Help!

    I have 1956 case 310 utility. It has always took 1 gallon of hydro oil every time I use it as it leaks out and I guess goes into transmission. Recently I started using the hand clutch with a bush hog so I could Engage PTO first, then the tractor. I am back to box blading now where I am not...
  4. C

    HELP case 310 gas

    I need some Help please. I have a 56 case 310 utilitiy converted to gas. I haven't ran tractor in several years. It cranked right up but it now surges with the governor like revs up then revs down and almost quits then it revs up and down again? I did have to replace the clogged fuel filter...
  5. C

    CASE 310 question

    Well after several hours of trying to get the gears shifting forks aligned I finally got it. I think the problem was I took the cover off while it was in reverse. I need some other help now. Haven't ran tractor in several years. It cranked right up but it now surges with the governor like revs...
  6. C

    CASE 310 question

    Joe Thank you!!! You don't know how much this will help me. I will try to work on it this weekend and let y'all know what I find here. thanks again!!!
  7. C

    CASE 310 question

    I have a 1956 case 310 utility. I have taken the cover off of the gear shift housing and cannot seem to get the shifter rods lined back up for it to go back on? It's the 12 inch by 12 inch metal cover over the transmission where you shift the gears. It won't go flush because something is...
  8. C

    Case shift lever/gears

    I have a 1956 Case 310 utility. I have pulled the gear shifter lever housing out of the gears and cannot the shifter teeth and the gears to line back up to work properly. I am talking about the actual gear shifter lever and the (3) y-shaped things that change the gears underneath. It is held...
  9. C

    Case 310 utility help

    Thanks for the reply Joe. I will check it out ina few days and post a reply back as to what I find?
  10. C

    Case 310 utility help

    Thanks for the reply. It sounds like it is the rockshaft piston seals as the lift does leak slowly down. Where and how do I go in to the tractor to fix this, what should I look for, and what part numbers and place can I get them?
  11. C

    Case 310 utility help

    Can anyone help me with this question please. I have a 1956 case 310 utility. When I run my tractor for after several hours, I have to constantly keep putting transmission/hydrolic oil in, (on top of the gear shifter housing) to keep the lift working. If I do not the lift will not work...
  12. C

    HELP Case 300

    Sorry for the confusion mEL. I should have ran home after work, and checked the oil as of the other day when I stated it was full. I knew I had checked the oil a while back when I changed it, and I just figured it was still that way, since I was not loosing 90W oil. I had no idea that the...
  13. C

    HELP Case 300

    My tractor is a 56 310 Utility also.
  14. C

    HELP Case 300

    OK, Maybe We are getting somewhere here, and thanks for the reply thus far. When I rebuilt the Motor approx 4 years ago. I read the manual and checked the hydrolic fluid with the dipstick that is located near the gear shifter, and filled it to full by the dipstick. I did the same in the rear...
  15. C

    HELP Case 300

    The level is correct on the rear gear box. my leak is coming out of the shift shaft when you engage the pto to come on. Its the only place on the tractor I can find that is leaking and I keep losing large quantaties of Hydrolic oil over several days seeping out. It looks very clear like new...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top