(800) 853-2651
SHOP NOW

Recent content by cdeleo

Yesterday's Tractor Forums
  1. C

    serial number

    or maybe the number is supposed to be 4420008U5095? Anyone with any info?
  2. C

    serial number

    jm, Thanks this is the number that I found. Wasn't what I thought I was going to find. Was expecting a number like 442xxxxU. unless it is just the xxxx part so 4425095U? Not sure if the 8 in the picture is part of the number or not? Thanks, Chris
  3. C

    serial number

    I'm trying to find a serial number on a td8e. the plate that is down by your feet on the driver seat is gone. Anyone know where else a serial number would be? Serial number on the engine may help also Dresser TD8E
  4. C

    TD8E steering issue

    rear end
  5. C

    12 or 24

    I don't have a TD7C but I have a TD8E with a dt239 motor and I use a single 12V 900cca and turns over and starts every time. However I believe originally it did have two batteries in parallel.
  6. C

    TD8E steering issue

    jm, I sent you an e-mail the other day just wanted to see if you got it. Also I took a look in the rear end of the dozer through the rear access panel. I saw what looked to be like two hydraulic cylinders on each side with a spring on each side. I had my wife pull back on each of the steering...
  7. C

    TD8E steering issue

    jm, I feel like such a noob. I don't know how to send an e-mail to you through here or how to get your e-mail address. In any event I took a look in the rear end of the dozer through the rear access panel. I saw what looked to be like two hydraulic cylinders on each side with a spring on each...
  8. C

    TD8E steering issue

    Ok so what I'm getting is that when I pull back on the left steering lever it should stop the left track (left side when operating the dozer). however it doesn't seem to stop the left track completely just kind of slows is it down. Sometimes it will stop it completely but most of the time just...
  9. C

    TD8E steering issue

    I've uploaded an image can someone tell me if the nut I circled is the correct one for the steering adjustment?
  10. C

    TD8E steering issue

    This message is a reply to an archived post by D15DAN on July 22, 2011 at 08:10:28. The original subject was "Re: TD8E steering issue". Rob R or JM, I have TD8E also with the same steering problem. I looked at the 2 o"clock position on the rear drive sprockets and I didn"t see a 3/4" square...
  11. C

    TD-8E Motor Mounts

    Hello, I have a TD8E that looks to me like it has lost a motor mount or two. The U-Joint under the floor boards looks like the motor side has dropped about a full inch. Can anyone give me some info of where and what type of motor mounts I would replace with. Or if I"m wrong in suggesting...
  12. C

    TD8E DT239 Turbo

    Thanks for the replys, the cast sleeve is exactly what it was. I did end up giving it to the shop with the turbo. It was very rusted and I had to purchase a new one. It was $87 is there anything on these that are cheap???. Anyway I'm all set and back up and running thanks for the info.
  13. C

    TD8E DT239 Turbo

    Hello all, I am trying to replace a turbo on a 1978 TD8E with the DT239 engine. The turbo is a AiResearch T04B20 turbo and I am having some difficulty getting the exhaust to match up with the turbo. The easiest way is probably to look at the pictures. Sorry for the bad picture it was done...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top