(800) 853-2651
SHOP NOW

Recent content by Chasing_Deere

Yesterday's Tractor Forums
  1. C

    720 diesel clutch adj. problems

    Not sure if you did but need to have clutch engaged when you set the clearance on the flywheel and something against the clutch pulley holding it to the left.
  2. C

    jd 730 taper lock

    The clutch should be engaged when you set your flywheel gap and tighten.
  3. C

    Price opinion on a 1937 John Deere B

    Randy what is your location?
  4. C

    Parts Tractors

    Where you located? Why are they being parted out?
  5. C

    Smoking Generator

    To polarize you should be touching momentarily bat to gen on the voltage reg with engine not running. Not A to Bat like you said.
  6. C

    JD 70D part needed

    Not seeing them on there now call Ryan Lind at this number he probably has one. 812 987-3982
  7. C

    JD 70D part needed

    They sell them on ebay I bought the ones for my 720d standard on ebay
  8. C

    1950 A Clutch slipping

    No its a very early 50 they started at 640xxx serial number in 1950
  9. C

    1950 A Clutch slipping

    Ok thanks guys for your responses we ordered new parts see how we make out.
  10. C

    1950 A Clutch slipping

    No its correct these were the parts used up to serial number 647999 and this tractor serial number starts with 642
  11. C

    1950 A Clutch slipping

    This is the parts diagram.
  12. C

    1950 A Clutch slipping

    I checked that and theres only two plates in this one and they looked right. Kinda hard to mess that up I guess with only two plates.
  13. C

    1950 A Clutch slipping

    Hello I'm working on a 50 A for my father in law he states that with the clutch engaged and in 2nd gear he can hit the brakes to put it under load and it slips. The clutch parts all look good and the snap is good we even set it a little tight and it did the same thing. Anyone know what else...
  14. C

    620

    The tractor sat for maybe a week with gas in the oil. The oil pressure now is the same as it was before it happened. Thanks for the help and info.
  15. C

    620

    Are you referring to #29 in this drawing?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top