(800) 853-2651
SHOP NOW

Recent content by cory eneks

Yesterday's Tractor Forums
  1. C

    pto shaft

    so basicly the shaft and the bearings should all come out together,,,and the kit should go back in????????
  2. C

    pto shaft

    first what is a PITA job
  3. C

    pto shaft

    just woundering how hard it is to replace a broke pto shaft on a 48 8n ford,,,,and should all the bearings be replaced???????thanks
  4. C

    small question hydraulic?

    ok thanks guys
  5. C

    small question hydraulic?

    ok guys 8n 48 ford,,,what is the best but cheapest hydraulic oil i can get for this tractor???????
  6. C

    fuel problem help

    hey i got it going!!!!!!!it ended up being in my distributor...at least now everything is new..it was behind the points,, i took the plate out and the counter weights were messed up i fixed em and it fired right up!!!!!!thanks for all the help yall,,,im sure i will be back on here soon,,thanks again
  7. C

    fuel problem help

    ok dell i did that,same thing,could it b the governer????or what size fuel line????
  8. C

    fuel problem help

    ok 8n 48 12volt new carb new fuel line,new gas,new sedament gas bowl,new plugs tractor will run for bout 10seconds then die.it sounds like its not getting gas,i have adjusted the mixture on the carb according to the manual,,and the carb still floods,and havent used the choke,could it be the...
  9. C

    it STILL FLOODS...please help

    ok guys 8n 48 ford 12volt.put new starter,new coil new carb,new manifold,new fuel line,new plugs and the DANG THANG STILLS FLOODS!!!!! it tries to fire,,but wont start..all plugs do fire i dont know what to do,,can someone help me??????
  10. C

    carb keeps flooding and wont start

    i have a 48 8n ford 12volt that wont start.i have a new starter,manifold,and rebuilt carb.when i try to start it,it trys to fire,i can hear it, then nothing and then the carb is flooded,so i take it off, drain it, check the floats put it back on,,then i clean the plugs and they are black as the...
  11. C

    transmission stuck.....help????48 8n,ford

    ok,,i was running in first and went to shift into 2nd gear without stopping ,,,,stupid me,,,now it wont go,,i let out on the clutch and it dies,,can someone help me,,,i already have the cover off,,,ooo by the way it is an 8n ford,,bout a 48yr,,thanks
  12. C

    new carb

    ok i was running my 48 8n ford tractor it would run for a minute than die.so i went ahead and put a new carburator a new coil and a new distributor cap on.what is the right calaborations for the screws on the carburator,,,when i put it on it looked like to me that it was flooding and i dont know...
  13. C

    new carb

    i just put a new carb on 48 8n tractor new distributor cap and coil and it still wont run it looks like carb is flooding can someone help thanks yall....
  14. C

    GB in MT

    hey go get an f0-4 manual it has it all in there good luck
  15. C

    Hydraulic pump

    ron8n do you have a governor housing i need one for a 49 8n hey let me know...cory [email protected]
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top