(800) 853-2651
SHOP NOW

Recent content by Dagmo

Yesterday's Tractor Forums
  1. D

    MF200 loader pump

    I tried JB Weld but it only lasted a few hours. I found a new intermediate shaft, the old one had a really worn female keyed end. Maybe I could dress up the pump shaft a little, and with the new intermediate shaft I could try the JB Weld again.
  2. D

    MF200 loader pump

    I'm replacing the 11" shaft from the pully to the pump, but I can't seem to find just the keyed shaft on the pump itself. The break down calls it a drive gear assembly. It meshes with another gear in the pump. This pump shaft connects to the intermediate shaft.
  3. D

    MF200 loader pump

    Where can you get a new drive gear assembly for a 1962 Cessna loader pump? The key slot is a little damaged. I'm putting in a new shaft drive. Or maybe epoxy?
  4. D

    MF35

    The shaft looked good. I was thinking maybe a pressure issue? I had the steering cranked all the way to the left doing some pushing through some brush and I noticed it after that. I remember watching a vid of Bundy Bears Shed and he was showing the pressure changes when the steering is cranked...
  5. D

    MF35

    I put in a new steering shaft seal on my 1963 MF35 loader. It worked fine for a few hours but it started leaking badly again. What would cause this issue?
  6. D

    Can't find power steering hoses

    Thanks everyone for your responses, it's greatly appreciated. Thanks Stan, I think that's exactly what I need.
  7. D

    Can't find power steering hoses

    The steering tower is the same but the pump is a different style. The hoses I need go from 2 tee blocks in front of the tower to the cylinders at the front wheels. 4 hoses, they all look like the one in the pic. About 41" long.
  8. D

    Can't find power steering hoses

    Perkins A3.152
  9. D

    Can't find power steering hoses

    I don't have a local MF dealer. About 3 hours away.
  10. D

    Can't find power steering hoses

    A 1/4" compression cap fits perfectly.
  11. D

    Can't find power steering hoses

    Will do.
  12. D

    Can't find power steering hoses

    I have a 1962 MF35 utility/industrial tractor with front loader and factory power steering. I tried to replace the power steering hoses, but nobody has the correct fittings to make new ones. It looks like 3/8 hose with small brake line size ends. Any ideas?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top