(800) 853-2651
SHOP NOW

Recent content by dan m

Yesterday's Tractor Forums
  1. D

    66 bullgears

    i was doing a swap with my 66 and a super 66. the splines were the same, but the gears is the super were a little wider. they worked ok.
  2. D

    TrackerPull database

    i know of the system, and the lady that developed it. that is the contact you show. she showed me how it worked. seemed to be rather user friendly. i was using spread sheet and never got back with her on getting a copy.
  3. D

    oliver 70 with a 265 waukesha

    very doubtfull. the 70 mounts alot different than the 88.
  4. D

    Oliver 77 Carburetor Problem

    is this a marvel sheibler carb? if so check to make sure the emulsion tube is there. if it is check to make sure it is clean and tight. just one of those things i've ran across with those symptoms.
  5. D

    Oliver 77 Carburetor Problem

    is this a marvel sheibler carb? if so check to make sure the emulsion tube is there. if it is check to make sure it is clean and tight. just one of those things i've ran across with those symptoms.
  6. D

    engine sleeve

    most cylinder sleeves are cast iron. most cylinder blocks are cast iron. like materials will usually have like expansion rates. with steel sleeves do you know what piston clearence to run?
  7. D

    wet sleeve

    the 1/8" wall will hold in this application. i would run head up fit in the lower block, and a flange at the deck. the problem i've seen with a straight sleeve in a h block, is the head chamber and gasket doesn't sit on the sleeve all the way around. the deck is weak and leaks where it hangs...
  8. D

    compression

    in simpler terms. increase in compression will increase horse power at all r.p.ms.
  9. D

    need valves for my daughters 70 oliver

    www.maibachtractor.com or 330 939 4192.
  10. D

    need valves for my daughters 70 oliver

    we got a set last winter at maibach's
  11. D

    Cockshutt 30 not firing on # 4

    just had a similar problem with a massey, we brebuilt. it ran fine about 2 weeks then started missing on #3. play roullette with plugs &wires didn"t change. good compression on all cylinders. found the new chinese intake, where i clearenced it so it could be bolted on. got a hole in it. welded...
  12. D

    1755 harmonic ballancer

    Tim Smith in Dalton, OH. has good used ones
  13. D

    Oliver 77 Engine Build

    mantua,oh. sorry i forgot to leave e-mail open. phone 3302742811 hours are 9:00 to 6:00 weekdays, 9:00 to 1:00 on sat.
  14. D

    Oliver 77 Engine Build

    we're in northeast ohio. have built them to 460 cu.in.
  15. D

    Governor problems on many Olivers?

    most problems i have found, are improper adjustment.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top