(800) 853-2651
SHOP NOW

Recent content by Danny Boy

Yesterday's Tractor Forums
  1. D

    MF 2607 heats up

    It was the radiator...so much for dealer flush. IMO the engine radiator is not big enough and is located in a tough place to reach for adequate clean out. Several other cooler/radiator units stacked in front of it. Thanks
  2. D

    MF 2607 heats up

    Just took water pump apart...impeller perfect (no broken fins, no slippage on shaft) channels on both sides of pump clear and clean. Guess its got to be the radiator?
  3. D

    MF 2607 heats up

    Thank you...that's our next move.
  4. D

    MF 2607 heats up

    Factory belt with proper tension...strong air flow. I guess its down to radiator or water pump.
  5. D

    MF 2607 heats up

    Changed the temp sender today and still heating up. Scanned engine while gauge was in the red (after 20 min at PTO rpm for 3-pt sprayer) and got: 180 deg ave on radiator 195 deg on water pump 205-212 deg on injector side of block 220-225 deg on exhaust/turbo side of block Gauge cooled down to...
  6. D

    MF 2607 heats up

    Gauge goes to the red after 20 min or so in light duty...will cool down intermittently with cool water sprayed on radiator, then right back up. Have--removed thermostat, checked water pump (belt tension/no leaks/no squeaks/good flow), coolant full, radiator cap good, cleaned radiator well many...
  7. D

    MF 2607 heats up

    MF 2607 heats up under low/no load use. Have tried everything suggested by MF with no success. Last attempt is temp sender and gauge. Anybody have same problem with late model MF? Thanks
  8. D

    JD GM oil drain plug removal

    Got it out...PB Blaster, tapped with small hammer from underneath and all 4 sides repeatedly. Had a worn 12pt 5/8 socket that I drove on the plug and my 30 yr old son broke it loose with a 1/2" breaker bar. Looked like it had some kind of pipe cement or loc-tight on it. Thanks for the suggestions.
  9. D

    JD GM oil drain plug removal

    square drain plug won't budge...any secrets to special wrenches or methods of getting off? Thanks
  10. D

    DLTX 71 carb rebuild

    Who would be best contact for rebuilding a DLTX-71 carb from 51 JD A?
  11. D

    51 JD A carb issue

    I had checked for air leaks in carb mount bolts/gasket and also had clear intake. I thought I had plenty of hot spark all way to plugs via ign switch and wiring, but will check again. Thanks
  12. D

    51 JD A carb issue

    New float & needle valve working properly. Having reviewed all searched forum topics on late model A with DLTX-71, no suggestions/recommendations have solved my problem. This tractor starts on first turn of flywheel with a little choke...but immediately begins hunting-flooding cycle regardless...
  13. D

    51 JD A carb issue

    I know this is an old story, but couldn't find a solution in searches. I have a 51 A with DLTX-71 carb that ran/started great until last year. Started running rougher, with governor hunting then surging so I rebuilt carb and put points/plugs in late last summer. When I put it back together, it...
  14. D

    Ford Jubilee carb

    What is best replacement carb available for Ford Jubilee? It currently has Marvel-Schebler. I want one ready to bolt on and go for summer tractor shows...tired of trying to make the original work.
  15. D

    DRAINING COOLANT/ANTIFREEZE

    THANK ALL!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top