(800) 853-2651
SHOP NOW

Recent content by Darby Clack

Yesterday's Tractor Forums
  1. D

    PTO Selector pin MF175

    I was bush hogging the other week and the pin that goes through the lever that you select your pto with snapped and fell out I tried to run a normal coil pin through it but there is to much slop to put it into engine pto does anyone know if there’s a special pin when I look it up it just shows a...
  2. D

    Clutch of MF 175

    It’s a 2 stage clutch and I can put it in 1st and 2nd easy it wouldn’t go into 3rd gear until I adjusted it but it won’t go into any of them in high gear unless I slam it the clutch isn’t disengaging so the tractor won’t stop
  3. D

    Clutch of MF 175

    Will go into every gear but is hard to get to go in high it makes a bad noise but if I pull hard enough it will go. It wouldn’t go into 3rd but I adjusted the clutch and now it will go in. It won’t stop the tractor either but there is a lot of slack in the holes the pins go into it has about 2...
  4. D

    Mf 175 ignition switch no power

    Unplugged the neutral ground safety switch when I turn the key on wire gets power tried touching them together nothing happened
  5. D

    Mf 175 ignition switch no power

    Just tested ignition plug one prong is hot, could it be neutral ground safety switch if so how could I test that?
  6. D

    Mf 175 ignition switch no power

    Diesel
  7. D

    Mf 175 ignition switch no power

    Bought a new ignition switch for a mf 175 that sat for 5 years and it’s getting no power I can start it with a screwdriver on the starter but I didn’t no if there are some fuses or relays some where that could be blown wire looks good that is running from switch the starter?
  8. D

    MF 175 stuck in reverse

    Jacked the tractor up today leveled it out gear popped right out I appreciate yall now gotta figure out why they ignition switch isn’t getting power adjust the clutch and brakes and she will be ready to go 👍🏻
  9. D

    MF 175 stuck in reverse

    Also stuck in low gear can’t get it to come out either ?
  10. D

    MF 175 stuck in reverse

    Started a MF 175 the other day and ran good put it in reverse and it got stuck I had a bush hog on the back and it jack knifed up on it because the pull to stop is broke I can’t get it to come out of gear I’ve saw people go through the filler cap and pry the gear back but they say on an incline...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top