-
D
Stuck Intake Valves
So what i did .......... was apply some heat to the side of the block and the valves began to move enough to fire it off and it quickly hit on all four. With 4 gallons of NEW fuel and a quart of ATF added to it I cut the front three acres. The tractor sat all night and fired right up this...- Dave_N_Ga
- Post #1
- Forum: Ford 9N, 2N & 8N
-
D
Stuck Intake Valves
I would like to add that if I turn the engine over, the valves stick open. After 10 - 15 minutes they will close on their own only to stick open again when the engine is turned over. Something definitely gummed them up.- Dave_N_Ga
- Post #1
- Forum: Ford 9N, 2N & 8N
-
D
Stuck Intake Valves
I took the 51 out yesterday, changed the oil and lubed it. Put about an hour on it and then let it sit. When I tried to re-start it last night it spun like it had no compression. That"s because it doesn"t, ALL 4 intake valves are stuck open. The gas does smell a bit sour but the tractor ran...- Dave_N_Ga
- Thread
- Replies: 7
- Forum: Ford 9N, 2N & 8N
-
D
Overrunning Clutch - recomendations?
I did order one from AgiSupply for $32. I can get too hurt for that price. Any suggestions for the long term??- Dave_N_Ga
- Post #1
- Forum: Ford 9N, 2N & 8N
-
D
Overrunning Clutch - recomendations?
The Overrunning clutch on my 8N failed today after many years of service. TSS has them but is there a better quality clutch out there I should consider? I"m not in a rush and want one that will provide years of service like the last one. I use a finish mower, brush hog, and flail from time to...- Dave_N_Ga
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
-
D
3400 FEL/BH - Noisy Hydraulics
Gents, The filter is 6 +/- years old, I don't remember the brand of fluid but it's a brand name meeting the Ford specification. A dicked up suction line coupling is possible, I wouldn't think that would change with the warmer weather but I can drain the system and replace them. just to... -
D
3400 FEL/BH - Noisy Hydraulics
During the cooler weather, the hydraulic system on my 3400 vibrates and has a whine or screem type noise when powering the FEL or BH. All the actuators have the same symptoms. The pressure is also low on the direct reading system gauge when loading the hydraulic system. The noise and vibration... -
D
HELP - Lucas Generator, Ford 3400
My genny quit putting out, gen light stays on dim with the engine running. I"m looking for some detailed help in figuring out what exactly is wrong. I"ve done quit a bit of seaching in the forunm, all I can find is the motor test of the generator. Before I try that I want to make sure I"m... -
D
3000 Ford Clutch
"one of the clutch finger pivot pins, fell out laying in the bottom of the bell housing" Had the same thing happen to me ........ -
D
3400 Steering Box Cracked
Hey Jerry, I won't bore you with my tales of woe but I desperately need my 3400 back together and if that steering gear housing is still available and you want to sell it to me I'd like to buy it asap. Let me know, Dave -
D
3000/3400 Steering Gear Seals Gaskets
I"m doing a rebuild/restoration on my 3400 steering gear. Is there a seal and gasket kit available or do I have to order individual parts. Where is a good place to order this stuff from? Thanks! Dave -
D
3400 Steering Box Cracked
Gents, Was using the 3400 yesterday, heard a pop and the front wheeels were aiming opposite ways. The steering box housing split open from steering arm to steering arm. It looks like there was an existing crack that finally let go. The tractor has power steering and I would like to know if... -
D
3500 ford w/ backhoe
My 3400 with a 753 hoe has a 13 gpm vane pump and puts out 2k psi all day. Controls are responsive, I guess a higher volume pump wont hurt anything, you may to feather the controls a little more often.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy