(800) 853-2651
SHOP NOW

Recent content by Detective

Yesterday's Tractor Forums
  1. D

    Steering gear box

    Sorry, I meant that I had replaced the top bearing in the column and I noticed that the bearing that sits in the bottom of the column was shot, so I replaced it. It was after that, I noticed the steering wheel going up and down. It is steering hard, also. I guess I should have just rebuilt at...
  2. D

    Steering gear box

    On my late model 8N, I just replaced the top end of the steering column. Now I notice that when the steering wheel turns right, the steering wheel goes down on the column and then goes back up when turned back to the left. If I need to remove and rebuild the gear box, what are the parts that I...
  3. D

    Lift arm pin

    Can I remove the left trumpet without taking the hub/brake assembly apart?? And "yes" I do have a leak.... Thanks
  4. D

    Lift arm pin

    I have a lift arm attaching pin that is loose. How can this be tightened ? Is there a nut in the differental housing? Thanks for your help
  5. D

    Steering shaft

    The top bearing on the steering shaft has never been removed. I am having trouble getting it out to replace it. Is there a special way to get it out? I'm ready to apply heat. Thanks for your help.
  6. D

    Spindle bushings

    Top and bottom so it's 4 per front end.
  7. D

    Spindle bushings

    Does it take a special tool to remove and replace the front spindle bushings on an 8N?
  8. D

    Freeze Plug on 8N

    Just had the block boiled out and after putting everything back in it, I noticed the pin hole in one of the freeze plugs. Thanks
  9. D

    Freeze Plug on 8N

    Has anyone had to remove an original freeze plug from a block ? Does it just pry out ? Mine has a pin hole in it.
  10. D

    TE20 voltage regulator

    I'll try checking the points of the regulator. It is a new 6 volt regulator for a Lucas Generator on a TE20. Thanks for the thoughts...
  11. D

    TE20 voltage regulator

    I put on a new voltage regulator on my 6 volt TE20. The Amp gauge pegs out and I even have a new battery. Why???
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top