Recent content by Dew3600

  1. D

    3600 Gasser Fuel tank sending unit

    Ultradog, Just wanted to let you know I got my fuel gage working on me 3600. It was a combination of the sending unit and a bad wire from the sending unit to the gage it is working good all is well life is good in Indiana. Thanks for your help. Dave
  2. D

    3600 Gasser Fuel tank sending unit

    Thanks I'll check it out and let you know?
  3. D

    3600 Gasser Fuel tank sending unit

    No I didn't how would I do that?
  4. D

    3600 Gasser Fuel tank sending unit

    I replaced the instrument cluster in my 3600 gas tractor and now the fuel gage doesn't work. I was told by a couple of people that the sending unit might not be compatible with the new gage. I have purchased a new sending unit and I am getting ready to install it and was wondering if there are...
  5. D

    My ford died

    I replaced the Holly on my 3600 with the zenith carb and it runs great
  6. D

    3600 3 pt

    That was what it was the lift control lever was in the full forward position thank you very much Ultradog for your advice.
  7. D

    3600 3 pt

    I need HELP! I have a 3600 gaser that the 3pt worked fine last winter when it was parked. I went out today to hook up the mower and the 3pt won't move up or down. Any help would be greatly appreciated!
  8. D

    3600 Instrument Cluster Replace

    Thanks for all the help! now I know why the gas gauge doesn't work either.
  9. D

    3600 Instrument Cluster Replace

    How would I be able to tell if I have that kind of gauge? And if I understand right if I do have that kind I don't need a Stabilizer at all?
  10. D

    3600 Instrument Cluster Replace

    I am replacing the instrument cluster in my 3600 gasser and I had to get the voltage Stabilizer separate. My question is can anyone tell me which wire goes where. The stabilizer has 2 sets of terminals on it one set labeled B and the other labeled I Thanks in advance for any help. (Old...
  11. D

    Hyd levers

    Thanks for the information that is what I thought they were. Thanks Again and MERRY CHRISTMAS TO ALL!
  12. D

    Hyd levers

    But what do they do?
  13. D

    Hyd levers

    I have a 1977 Ford 3600 Gas Tractor that has two levers under the seat I know that they go to the rear hyd conections but I don't know how to operate them they are both very stiff to move. Hope someone out there can help me out with some info on these levers
  14. D

    3600 Starter Drive Replace

    Is there anything special about changing the starter drive on a 1977 Ford 3600 Gas?
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top