(800) 853-2651
SHOP NOW

Recent content by dlp

Yesterday's Tractor Forums
  1. D

    jubilee hydraulics

    Sometime back, I rebuilt the square hydraulic pump on my father-in-laws Jubilee. I used it the other day & noticed a problem. When lifted to the top with a bushhog on it, it would drop a little bit & then come back up, drop again, & repeat this consistently. What is up with it? Thanks in advance!
  2. D

    100 trans level

    How do you check oil level for trans/differential?
  3. D

    Flat lense bulb

    Originally they were. I changed it over to 12vdc, so I need a part number for the bulb. As cars used 1156,1157, etc., I need the number for this type.
  4. D

    Flat lense bulb

    What is the number for the 12vdc flange bulb that fits a flat face light? Thanks!
  5. D

    R Governor

    I take mine apart & install new bushings. The vertical rod is pulled out, hole drilled oversize about 1/2" down, & a bush is pressed in (can't remember the bushing size right now). I also had to shorten the rod to carb a little to take out slack. Seems to me like the shaft may be shimmed, but...
  6. D

    Chevy valve springs in a Z

    I know they will fit, but do they have to much tension for the Z engine? Will the rockers flex/bend? I also wonder about premature cam shaft wear? Thanks!
  7. D

    LP Question

    Hyster forklifts used the Impco systems for a lot of years. The system you want was used on XL series. It will be two pieces, a lock-off & convertor.
  8. D

    Z oil cap

    Anyone know where I can get the small oil cap for my ZTU? Also, I saw a cap for a Farmall 140 in an add that also looked like it. Will it work? Thanks!
  9. D

    W-30 head bolt torque

    What's the torque setting for head bolts on a W-30 engine? Thanks!
  10. D

    Sachs Dolmar 114

    I need some help with my ignition on my 114. Mine just died one day. Is it the coil or the pick-up that fails? How can I test it? I read somewhere that a PS6000, PS6800, 116si, or 120si coil will work. Any help on getting me going again would be greatly appreciated. Thanks!
  11. D

    Front wheel bearings

    Can someone tell me the Timkin number for the inner & outer bearings for an early Z? I have one with the large, cast clamp-on centers.
  12. D

    ZTU fan belt

    What size is the fan belt for my ZTU? Thanks!
  13. D

    Sachs Dolmar 114

    I have no fire from the coil. No short to frame. Does the coil go bad or does the pick-up under the flywheel fail? I have been told this is a discontinued item from factory. Is there an aftermarket available? Thanks in advance!
  14. D

    Sick Stihl 029wb

    This saw starts well when cold. When it gets warm to hot it starts loosing power & shuts down. Fuel is not a problem. The spark, however, is another issue. If I crank it easy, it will not fire the plug. If I pull hard & spin the motor really fast, it will fire a blue steady arc. I have changed...
  15. D

    Internal mag timing on K4B

    I took 3 mags a part to build one. Everything is good, I have fire, but I'm not sure about the internal timing. With the cam high sides up & down, I put the "c" mark on the fiber gear up on the right side of the bearing plate, just across from the plate retaining screw. I guess there is what I...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top