Recent content by Dnelson2

  1. S

    update on my 95 Chevy Truck

    I asked a mechanic about it losing power and he said it was one of two problems. Fuel delivery. And I said I had put a new pump and filter in it. Then you must have a plugged Catalytic converter. I removed it and it has run without any problems since. My brothers 94 would develop a miss ever...
  2. S

    JD 2010 Electrical ?

    I have a 64 JD 2010 issue with starting. In the past I always have to change the ignition switch about every 2 years. I first need some help on the wiring back of the switch since I lost my electrical diagram for that. My fault since I did not replace one wire at a time. The next part would...
  3. D

    Wiring help with JD B/L

    Hello, this is the place I come anytime I am stumped or need information I cannot find. Today my 1984 (someone called it an 81) John Deere backhoe loader had a dead new set of JD batteries was dead. I jumped it with my 200amp start (scares me, seems to have too many amps!)and I saw a glow. The...
  4. L

    BLADE ON A 756 WITH A DO MOR BLADE

    Fellas--gals--I have a photo and question up above in the tractor forum---take a look at my pic and question if ya have the time. Thank you
  5. P

    landscape rake

    Hi all, Any one have any input on the pros and cons of wheeels on a seven foot york type landscape rake? Adding wheels adds considerable $$$ to the cost. Thanks paul
  6. A

    Grain drill

    I have a McCormick grain drill which is a double run. I am looking for the reducers that go in the seed cups. It says mdrf on the side of the seed box. Any help is appreciated thanks.
  7. J

    Problem solved

    Just a few words to say how much help this site has been. My 8N has had problems with starting and running under load. I tried new plugs, new points and condensor, checked fuel flow through carburator, air filter for rats nest, and wired out carb. orifices with an old banjo string. Then I read...
  8. A

    MH 80 engine speeds

    Does anyone have the High Idle and Full Load engine speeds for this tractor? Later Bob
  9. A

    NATPA logo

    Does anyone have a high quality jpg of the NATPA logo like the one on their website? I need it ASAP if possible. This is the Cornhusker Classic Indoor Tractor Pull in Lincoln, NE.
  10. D

    Hydraulic cylinder

    I have a freeman loader and the center cylinder broke. Need to find replacement. No luck so far 32" pin to pin 18 " stroke 2 1/2" bore 1 1/2" piston dia the problem seems to be the 32" pin to pin. Looking for new or used any suggestions please
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top