Recent content by doa44green

  1. D

    Case Plow identification

    I have one just like it. My dad bought it new in 1954. It's a Centenial plow.
  2. D

    IH 656carb issues

    I have a IH 656 with a IH carb with the solenoid disabled. I want to install a load mixture screw that needs 32 threads per inch and .423 in diameter. None of the older generation of carbs have that size thread in the carb mixture opening. The only replacable screws are 3/8 x 24. Has anyone...
  3. D

    John deere 2510

    I have a good used 4 piston 2510 pump that I replaced with a 8 piston. $100 plus shipping. Thank you! Don Anderson 608-525-2280
  4. D

    574 transmission pump

    With warm engine my transmission lube pump warning light comes on. A pressure check show almost no pressure at idle and very little at higher RPMs. Not enough flow in the circuit to be measured on my flow meter. How is this pump removed? According to the manual it can be done with access...
  5. D

    574 piston rings

    I need .040 over size piston rings for a 4 cylinder c200 gas engine for a 574 IH tractor. Can anyone help me? Thank you!! Don
  6. D

    Tire air blaster

    I am in the market for a tire bead expansion blaster. The two choices I have are a 5 gallon or a 10 gallon. The price difference is not very much. Does anyone have any advice for me as to which one I should purchase? Thank you in advance!! Don
  7. D

    Pre-1930 John Deere Dain Side Delivery Hay Rake

    I think I may have one in the woods. I'll try to send you some photos in a few days. Don
  8. D

    New idea mounted picker

    The parts manual shows a left and right "Roll Shield Assembly" mounted above the snapping rolls. These are not available for the same vintage of pull type pikers. Does anyone out there know what their purpose is? Thank you very much for ny input!, Deereford
  9. D

    JD 42 Combine

    I have purchased four 42s and have towed them all with my pickup. One I pulled several hundred miles. Just add some magnetic tail lights.
  10. D

    Combine

    What type of head is on it? Is it a square or round back? Thank you!
  11. D

    John Deere 630

    Go to Craig's list on the Eau Claire, WI site.
  12. D

    JD 7000 planter monitors

    I have a 100 and a 300 planter monitor. Neither one will work. I have checked the sensors and connections. All are good. Apparently I need them repaired. Where is a good place to have that service done? Thank you! Don
  13. D

    John deere #22 crimper part?

    I have both a 21 and 22 parts crimper. There should be at least one good shoe among the two, assuming the 21 and 22 are the same. I'll check and get back to you. Don
  14. D

    Case Centennial plow

    My father bought a brand new Case Centenial plow in the winter of 1954. It had steel wheels and 2 14" bottoms. I still have it.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top