-
D
Poll or old members
Read daily. Very informative and entertaining. I am thankful for the help I've received. Just not one to post much.- doneb
- Post #244
- Forum: Tractor & Farm Talk
-
D
Hydraulic remotes
It does help. I've ordered the tipped ones you have described so I'm certain now I've chosen the right ones. Thanks. -
D
Hydraulic remotes
This is the remote set up. The opening on the female coupler is about .935. Down inside where the nipple is looks to be about 5/8 " or larger. -
D
Hydraulic remotes
I'm wanting to use the hydraulic remotes on my 1959 881.I need the male half (poppet valve) to use on the implement hose. The parts manual gives the P/N as D3NN8964A which brings up nothing when searching online. Can someone tell me what size the valve is? Tried measuring the female half and it... -
D
SOS oil migration
I found the Napa p/n for the switch. It's only $14 so I'll go ahead and replace it. You suggestion is good though. -
D
SOS oil migration
Actually the lube pressure switch does not work and I plan on replacing it. I have looked in the parts manual and searched in these forums but can't find a part number for the switch even though I remember seeing it in this forum. Can someone give me a part number? -
D
SOS oil migration
x I do use the same oil in all three sumps. If I run the tractor long enough, it would empty the trans sump and over fill the hydraulic sump. I wouldn't want to use the tractor with little or no oil in the trans. -
D
SOS oil migration
[quoa te="showcrop"](reply to post at 05:45:56 12/02/20) About 2 months ago I got a post hole digger for it and used it to dig several holes with no problem. That's all I've used the PTO for -
D
SOS oil migration
Early this spring I damaged the splines on the intermediate PTO shaft on my 881. Just wasn't thinking. I got a replacement shaft and the necessary gaskets and o rings. Split the tractor, replaced it and reassembled. Everything works just fine. Since I don't use the tractor much it was only... -
D
Pto seal
Replaced the pto seal in my 1959 Ford 881. The new seal is not nearly as good as the old one. The old one had two lips to seal around the shaft and the new only has one. The new one didn't last long and now leaks worse than the old one ever did. Any suggestions on a good pto oil seal to use...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy