Recent content by dtkraj

  1. D

    1100 3pt quit

    Hi, I finished disking and went to put the chisel plow on and....... nothing! Everything else works fine, had the blade on a few days ago and it lifted big round bales easily all winter. I am going to take a flashlight after it and hope I find something stupid but I fear a valve is stuck or...
  2. D

    john deere 40 in pieces value

    I have a jd 40t tore apart that I don"t have time to put back together, too many irons in the fire. The tractor ran good but I didn"t want to run it because of excessive crankshaft play so I tore it apart and now it sits. The good- new head, good tires,front and rear wheel weights. The bad- beat...
  3. D

    tires for D14

    Watch e-bay, it took some time but I got lucky with a set of take-offs from a kubota. Someone bought a new kubota a couple years ago with ag tires on it and decided to switch to turf tires. I got the rear rims and tires for 500$ and they bolted right up, 14.9 x26. The other tires i was watching...
  4. D

    13.6-26 speedways grip king

    The 40 year old tires on our D-14 are getting pretty ifffy, anyone know anything about these? They are 460$ at M.E. Miller tire, local co-op can only find one in Wisconsin thru his suppliers and its almost 800$, he said to try the internet.Thanks
  5. D

    1100 lift pump

    I fixed it!!, but i'm not sure how exactly. The screen in sediment bulb had a little gunk on it and was torn, old pump seems to work off the tractor but new one primes with every stroke. on the filter side the drain petcock has a bad rubber washer and still leaks, will get one tomorrow. The rear...
  6. D

    Zenith carburetor for 2520

    This message is a reply to an archived post by jdtom on August 23, 2009 at 16:47:29. The original subject was "Zenith carburetor for 2520". Bump to top, I'm wondering same thing, could cost 300$ to rebuild old marvel on our 2520
  7. D

    Allis G Belly Mower question

    My buddy has two G's and I have a 60" swisher pull behind for my four wheeler that works good. I always told him he should try to mount one under a g like a belly mower, has its own engine.
  8. D

    1100 lift pump

    I have drained the tanks twice to replace the park pawl, hope to avoid that, tanks are chuck full. Dad says replace the pump and filters first- his checkbook so okay. I ordered a dirty-greasy-well used shop manual on e-bay last night for 18$ shipped. Maybe this weekend i'll change it,doesn't...
  9. D

    1100 lift pump

    The 1100 died on me three times today, I parked it and the 2520 gets to plow snow now. I,ll clean up everything best i can and change filters and the lift pump. We've had the tractor for 25 years and 4000+ hours and the pump has never been touched by us, Dad says just replace it. When I order...
  10. D

    Should I or Shouldn't I ?

    buy a bigger old garden tractor to play with and then plow snow with it, maybe mow lawn-earn its spot in the garage.
  11. D

    1100 lift pump

    I just came back from looking it over in the cold. I cleaned it off with shop towels and the air compressor. The gasket between the two halves looks wet with diesel fuel and I was able to tighten up all six screws easily about 2/3 of a turn if not more and I didn't really torque them much at...
  12. D

    1100 lift pump

    I have an 1100 that likes to die after about 15 - 20 minutes of plowing snow, I loosen the two bleeders on the injector pump and squeeze the lever on the lift pump about 50-60 times till fuel without bubbles comes out, shut the bleeders, crank her over and away we go . I know air has to be...
  13. D

    2520 and ta 25 loader

    Hi, a ta-25 has come up for sale locally with a joystick and 2510 mounts for 2500$. We have a 2520 and some 1500 lb bales to move. We are totally unfamiliar with loaders outside of the one on our d-14. Would this be a little light for big bales or just fine? How does it compare to a 148? Our...
  14. D

    52 M hydraulics

    Hi, we have a late M with a belly pump, two way hydraulics, hand clutch, and a 115 side-mount mower.When the tractor gets warm it will barely lift the mower so I drained all 2 quarts of quiklift and put in non detergent 40W hopeing that will help.I have read and heard some conflicting info. With...
  15. D

    489 haybine hitch

    Hi, We have a 489 with bad rolls and an even worse hitch pivot - not worth fixing. We are just hoping to limp it through for a little longer. I have heard and read that the hitch was a weak point on these, I was wondering if the later 492 and 1465 haybines addressed this problem. This haybine...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top