Recent content by DUMPS

  1. D

    John Deere 318 Hydro

    The tractor is running great. For some reason when I go in reverse the tractor moves real slow but does move. Tranny fluid ok in sight glass. No idea why it doing this.
  2. D

    Help needed for JD345

    Did your engine keep running for a few seconds after you shut it off? If it did you have a time delay mod. and it is located on one of the supports for the air cleaner. It is straped to the inside of the post. It costs about $18 bucks and is easy to replace. I believe it has three wires and...
  3. D

    Deere 318 starter won't engage

    While I had the starter out I would take it to an electrical repair shop that deals in starters and such and have them put a new set of brushes in it. Only costs Approx #20.00 but well worth it.
  4. D

    JD 318 hard to start

    Dear Dave in MS. Could you tell me were to connect the hot wire to. I imagine that it goes somewere on the ignition switch. thanks again for your help. Dumps
  5. D

    JD 318 hard to start

    Dave, Would you please post a photo of the installation of the fuel pump. thanks dumps
  6. D

    JD 318 hard to start

    I too have this problem. I have to choke it and run the starter until the battery almost dies before it starts. It seems like the fuel drains back into the tank. If I run it every day it starts right up.
  7. D

    John Deere 318

    thank you
  8. D

    John Deere 318

    I have a B43G engine and I need to know what the points (contacts) setting is.
  9. A

    upcoming show

    The 40th annual Tennessee-kentucky Threshermens Show will be held July 17, 18 at the Bell Schoolgrounds in adams, Tennessee. Some events held are tractor pulls on Fri The 40th annual Tennessee-kentucky Threshermens Show will be held July 17, 18 at the Bell Schoolgrounds in adams, Tennessee. Some...
  10. D

    Re: Donkey of the week

    Ahh..Now I see...(I think) You edited the name of the topic. From Dipstick to Donkey. That is why it is spawning the orphan RE:s on the modern board.
  11. F

    Might be buying an 8700

    Found an 8700 in Houston, MS I"m real interested in. Going to look at it Monday. It needs a cab interior & seat, and a new engine panel on rt. front side, but aside from those things the tractor looks great. Got 3190 hrs. on it. My concern is this: the dealer reports a slight noise in 6th gear...
  12. D

    OT: Mole chasing windmills

    PUT PEANUT BUTTER ON A MOUSE TRAP AND SET IT NEXT TO AN ACTIVE MOLE HOLE. COVER THE TRAP WITH A CARDBOARD BOX FOR THE NIGHT AND BINGO YOU HAVE THE MOLE IN THE MORNING. KEEP DOING THIS UNTIL YOU KILL THEM ALL. I HAVE TRIED ALL THE OTHER TRICKS OF THE TRADE BUT THIS ONE WORKS BEST.
  13. J

    Mr. now and Mr.Later

    Fuel prices here within 4 mile of each other $2.19. $2.17 and $2.11 Reg Unleaded as of the three I checked today. Mr. now is setting Mr Later up for a a bigger battle to try and straighten out the economy. If Mr. now can drop the oil prices to make him look good going out, then it was possible...
  14. D

    gx 345 running problems

    Mine acted the same way. it turned out to be the time delay moduel. it is located on the left side of the engine right above the starter. it is kind of hidden behind the support for the air cleaner housing. it has three or four wires on it and is replaced with ease. you can not mix up the...
  15. D

    JD 318 B43G CARB TROUBLES

    Dear newfy, (notice I took off the caps lock) I put in two new spark plugs and backed off adjustment screw 1 1/2 turns and it started right up and ran good. no need to rebuild carb at this time. got the plow and chains on and i'm ready for the snow that we are going to get this afternoon...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top