(800) 853-2651
SHOP NOW

Recent content by el60

Yesterday's Tractor Forums
  1. E

    New Holland L783 injection pump

    Diesel tech email me if you don't mind.
  2. E

    New Holland L783 injection pump

    Anyone know what injection pump that goes on a 201 diesel in a L783 new Holland skid steer?
  3. E

    60 John Deere roller rockers

    Has anyone ever used Murphy's 2.0 ratio rockers with a reground cam?
  4. E

    2cyl cam regrind

    Who does the best at cam regrinds on a 2cyl John Deere?
  5. E

    60 John deere

    I have a 60 John Deere I'm building. I have a 6-3 powerblock and plan on using G pistons. The question I have is what possible modifications could be done to the cylinder head to help with performance up grades?
  6. E

    40 Model B question

    I have a 1940 B. I am going to part it out in the near future. I pulled the head off and found the pistons are flat not dished. This is a 40 model all fuel is this what would have come from the factory or has someone put some pistons in this B? I have not measured the bore due to not having...
  7. E

    1937 unstyled B

    Can anyone send me a picture of the front pedestal and the frame of a 1937 unstyled B?
  8. E

    pulling 60 jd

    I have a 1955 model 60.I bought it just to pull in antique pulls. I am wondering if it would be better to swap the rear cast centers and rims for the lighter pressed steel wheels? And also remove the powertrol and install a flatback. When I bought this tractor I was told to get it as lite as I...
  9. E

    JD60 rear wheel weights

    Did JD or anybody make a set of hubs for the keyed axles on a 60 to run the pressed steel rims?
  10. E

    flathead for a G

    Does anyone have a flathead off of an unstyled G. I was told that putting a flathead oh this 53 G would really help me make more power for the tractor pull.
  11. E

    60 tranny fluid

    Yeah what would you fush the tranny and all with. Mine had some water in it. I would think that just draining and refilling you would still have some water oil mix in there.
  12. E

    60 tranny fluid

    what is the correct tranny oil and where do you refill once it is drained?
  13. E

    magneeto

    the mag I have came off running tractor.
  14. E

    5-1 b powerblock value

    Nevermind I can read if I open my eyes.
  15. E

    5-1 b powerblock value

    what does this powerblock fit?
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top