(800) 853-2651
SHOP NOW

Recent content by Enginedoc

Yesterday's Tractor Forums
  1. E

    35MF Gas -coil resistor

    as to by-passing the resistor, u can try that, but if the coil is bad, u wont get very far would be my guess. a 12 volt coil with internal resistor would be a better choice , and probably fix ur issue. again I can not stress enough test the system, ck voltage to and from the coil. u could...
  2. E

    35MF Gas -coil resistor

    T/S should have the parts u need. as to why? I have seen many scenarios in the past. make sure u have 12 volts at the coil, if not there is a wiring issue. condensation forms on ing parts, it turns white when warmed by voltage being applied to the circuit. if there is no pitting on the face of...
  3. E

    35MF Gas -coil resistor

    good suggestion. just a thought , I changed the coil on my IH 240 several yrs ago, put a 12 volt coil with an internal resistor, haven't changed the points since. again, just a thought Doc
  4. E

    anyone have any issues with 5045 or yanmar coolant leak?

    if the tractor is under warranty I'd call the dealer, it is there responsibility to remedy any issues u have. Doc
  5. E

    jd 2510 and jd2520 engineswap

    both engines r diesel thanks for ur reply Doc
  6. E

    jd 2510 and jd2520 engineswap

    thanks for this info, just found out that this same brother in-law just bought a 3010 with a bad engine. see what family gets u into lol. looks like were gona have fun fun fun this spring lol Thanks Doc
  7. E

    35MF Gas -coil resistor

    1st I suspect u will need a new set of points, and I'd change the condenser as well, they will go bad just sitting. ck the coil, I guess this is a 12volt tractor? id get the correct resistor from a supplier like tractor supply if there is 1 in ur area. the coils will also breakdown just...
  8. E

    case sc mags

    being we r looking for goodies, I'm in need of a couple of work condition case magnetos for my old sc's both tractor were my granddaddy's and I learned to drive on the 46 Thanks Doc
  9. E

    Went Yatching with my 440 today

    Tractor information a syrup in 1 place!!! what a place this is. keep me informed thanks Doc SC1938-1946 yep I got 2 of them
  10. E

    MASSY FERGUSON TO-30 wiring

    would any 1 have a wiring diagram handy for these? esp the generator and regulator Thanks Doc
  11. E

    Help finding an A oil ring

    Tisco is a good source also. u will need the actual diameter, so measure before u call. I agree with the other poster as to "used oil rings" trust us, might as well use what u have as to used rings that most probably will not seat. Hope this helps Doc
  12. E

    jd 2510 and jd2520 engineswap

    Tim thanks for ur input. Just cked with tisco and the use the same parts in both blocks, just diff liners
  13. E

    Wiring/electrical question

    Eric , If your tractor has an enclosed cab there should be a power receptacle on the rear of the console to the right of the operators seat. remove the cover and locate where its tied to the wiring harness. I have seen some folks wire these straight to the battery, if u do this DON'T FORGET TO...
  14. E

    jd 2510 and jd2520 engineswap

    I have a Jd2510,engine M53RA 3.3 ltr, an I want to know if any 1 knows if a 4219DN engine out of a high boy 6000 sprayer will work in the 2510 series. It seems this engine was used in the Jd2520 tractor. changing the ft and rear covers as well as the oil pan is not an issue , if the short block...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top