Recent content by facspro

  1. F

    NH 855 cylinder issues

    Use the pipe trick - thanks caterpillar guy - after clamping the pipe to the rod I was about an inch long for my press so I just turned it upside down and smacked it a couple good times on the concrete floor. Thats what it took! Still took a little while to get the spring clip out. Once it...
  2. F

    NH 855 cylinder issues

    Got the cylinder back on and back in business. And the tailgate stays up now without slowly creeping down. Thanks everyone. Now I just need to get the charging issue taken care of on the 4430 but that will be a different thread
  3. F

    NH 855 cylinder issues

    Got the cylinder back on and back in business. And the tailgate stays up now without slowly creeping down. Thanks everyone. Now I just need to get the charging issue taken care of on the 4430 but that will be a different thread
  4. F

    NH 855 cylinder issues

    Use the pipe trick - thanks caterpillar guy - after clamping the pipe to the rod I was about an inch long for my press so I just turned it upside down and smacked it a couple good times on the concrete floor. Thats what it took! Still took a little while to get the spring clip out. Once it...
  5. F

    NH 855 cylinder issues

    Another attempt at uploading the pictures
  6. F

    NH 855 cylinder issues

    Unfortunately there is an assembly welded to the shaft end for the safety latch that prevents a pipe from going over it - been trying to envision how to get something to fit around it As for the ring - the gap is barely 1/8 inch wide and everything I try to tap it with bends or breaks without...
  7. F

    NH 855 cylinder issues

    It doesnt look like the pictures went
  8. F

    NH 855 cylinder issues

    Trying To disassemble a tail gate cylinder. Ive read a few other threads on here but this one doesnt seem to be the same. Ive pulled the oil seal out and there is no snap ring under the oil seal the oil seal sits in a cup and there is a spring clip in between that cup and the cylinder wall body...
  9. F

    JD 620 Starter

    Put the starter in this morning and adjusted the linkage trying to keep minimal pressure on the starter switch. Spun right up. 620 hasn't started like that in a couple years. Hopefully the linkage adjustment will help save a few switches. Drilled about 25 acres of rye pulling an IH 150 shoe drill.
  10. F

    JD 620 Starter

    Damn! I'm almost embarrassed that I had to ask! She's back together and ready to go back in the tractor.Thanks for the quick reply.
  11. F

    JD 620 Starter

    the contact stud was worn down to nothing so I was going to replace it in hopes that it would help with the saddle switch issue so I figured I might as well put in new bushings, drive gear and brushes while I was at it. That and clean some of the rust and crud out of it.
  12. F

    JD 620 Starter

    trying to do a basic rebuild of the starter on my JD 620 LP without tearing it up- It has been eating these cheap starter switches for several months- I am trying to remove the drive gear but can't figure out how to remove the "Stop Ring". And YouTube wasnt any help. Thanks
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top