Trying To disassemble a tail gate cylinder. Ive read a few other threads on here but this one doesnt seem to be the same. Ive pulled the oil seal out and there is no snap ring under the oil seal the oil seal sits in a cup and there is a spring clip in between that cup and the cylinder wall body. I have tried to beat the cup assembly down yes I have the setscrew out and the hydraulic fitting out. I cant get them to budge I tried to clean out the groove with a Dremel tool and scraping tools with no luck I can see the two ends of the clip but I cant get it to compress at all or budge. I soaked it overnight in penetrating fluid to try to help break down the rust if thats whats causing the problem and that really hasnt helped I am at a loss as to how to get this spring clip out of here. I really dont want to beat on it anymore for fear of damaging the seal cup anymore than I already have. I am going to attempt to upload some pictures so hopefully they go