-
F
1020 governor
Ok, it just bugs down a little when you drop the plow in the ground and then catches up. I am also plowing alfalfa so that doesn?t help either. As long as I don?t kill it I?m fine cause I don?t wanna have to crank any more than I have too haha- Ford900
- Post #1
- Forum: Farmall, International & McCormick
-
F
1020 governor
Hello everybody, I got a 1928 McCormick 1020 with the old style governor where is only governs at full throttle, the problem I am having is when I am plowing when I drop the plow in the ground the governor is slow to respond, it eventually will catch up but it takes around 10 feet of plowing to...- Ford900
- Thread
- Replies: 4
- Forum: Farmall, International & McCormick
-
F
Tie rod end
I have a ford 960 with a bad tie rod end where is hooks to the steering sector arm. Does anybody know where I might be able to find one -
F
Draft control
Hello I got a ford 900 and I was wondering if anyone else has had the same problem as me. When I plow in draft control I have no control over the depth of the plow. The only thing that stops it from going deeper in the cutler hub, I'm thinking something in the draft control spring is rusted... -
F
Ferguson plow
Hello I broke a plow share on my ferguson ao 14 inch 2 bottom plow. The bottoms are general purpose r bottoms and and I was wondering if anybody still makes the shares for this plow -
F
Ford 960
I have a ford 960 and when it warms up the hydraulic pump starts to rattle, it only doesn't when the 3 point is not moving. If you raise the 3 point it will stop making noise until it's done moving. I have replace the wobble shaft, drive hear in the pump and the bearings. Please let me know what... -
F
Cold weather
The battery I have is only a 525 cold cranking amp so that is probly the problem because in the summer it starts as soon as you hit the button -
F
Cold weather
I've got a ford 960 and when it's cold it will only start good if I have a battery charger on it, it will crank but it will not start, what could be the problem -
F
Hydraulics
Thanks for the reply I throes the tractor today and every thing was fine with so I don't know what the deal was -
F
Hydraulics
I have a ford 960 tractor that I use for moving snow off my driveway. Yesterday when I started il the tractor it was about 25 degrees out. I let the tractor warm up and the blade lifted fine to drive out of the shed. When I set it down to start plowing it would raise up. So I bled the hydraulic...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy