-
F
8n spark help please
It has been fixed it was the ignition switch $16 bucks at tractor supply here in New Hampshire- fordmanmatt
- Post #1
- Forum: Ford 9N, 2N & 8N
-
F
8n spark help please
Ok so I tested I have no power to the coil or distributor I also have power to one side of the terminal block with the key on and off this has been converted to 12 volt and yes all of the wires are the right way- fordmanmatt
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
-
F
8n spark
i converted my 8n to twelve volt and now i have no spark i have done new points and plugs spark plug wire- fordmanmatt
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
-
F
12 volt conversion
do i have to change the starter solenoid when i change to 12 volt- fordmanmatt
- Thread
- Replies: 2
- Forum: Ford 9N, 2N & 8N
-
F
12 volt
iwas wondering if you guys could give me some pictures of your 12 volt 8n where the wires go- fordmanmatt
- Thread
- Replies: 5
- Forum: Ford 9N, 2N & 8N
-
F
8n hydraulics
Yes all gaskets done I wonder if it is the safety valve- fordmanmatt
- Post #1
- Forum: Ford 9N, 2N & 8N
-
F
8n hydraulics
just replaced the cylinder housing and piston and rings for the 3 pt hitch did not do the safety valve and the lift still drops after all this- fordmanmatt
- Thread
- Replies: 4
- Forum: Ford 9N, 2N & 8N
-
F
12 volt conversion
i have decided to go 12 volt on the 52 8n and i need help i need to know all the parts i need to buy i don't want to do this half a** i want it done right im pretty fussy about what i put in to the old girl is there instructions on how to do this- fordmanmatt
- Thread
- Replies: 11
- Forum: Ford 9N, 2N & 8N
-
F
loader snowplow
hi all looking for a loaderto put on an 8n just for a snow plow or some kind of snow plow setup any ideas on how to set up a plow or where i can get a loader- fordmanmatt
- Thread
- Replies: 17
- Forum: Ford 9N, 2N & 8N
-
F
8n paint
how would you paint around the engine on an 8n with out the paint burning is implement paint take the heat- fordmanmatt
- Thread
- Replies: 1
- Forum: Ford 9N, 2N & 8N
-
F
8n radiator fan
using the old 8n this weekend and the radiator fan seems very lose i can move it up and down about an inch and a half it looks like it is mounted on the water pump but i cant tell with out taking the hood off why would this be very lose- fordmanmatt
- Thread
- Replies: 6
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy