(800) 853-2651
SHOP NOW

Recent content by Ga Rick

Yesterday's Tractor Forums
  1. G

    Case IH 485 Hydraulic problems

    This morning I pulled up the filter off, checked both o’rings on the housing of the tractor and on the bolt. Both were fine, filter and screen are fine. Reinstalled making sure o’ring was in its groove. The pto will only turn if you rev the engine, removed the clutch inspection cover and the hub...
  2. G

    Case IH 485 Hydraulic problems

    I am helping my neighbor with a 1988 Case IH 485 that he just purchased. When he got it the 3 point hitch was slow to go up. He said he would raise the lever, it would take 5-10 seconds for it to raise. The hydraulic fluid was milky so he changed the fluid and the filter on the side of the...
  3. G

    Massey Ferguson 4253 again

    I have a 4243 with what I think is the factory radio. It has the 4 holes in the front of it to use the older Ford radio removal tools, just 2 u shaped pieces. Try to post a link.
  4. G

    Chevy 'crump' update

    I’ve worked on some of years trucks and SUV’s with a creaking noise on acceleration and braking. Turned out to be the crossmember bolts for the transmission or the crossmember one under oil pan will loosen up slightly and start making noise. Have them check and make sure they are good and tight.
  5. G

    tpm tire pressure monitor

    I bought an set of A/C Delco ones on eBay for my 2010 Silverado. I have a tire machine so I installed and programmed them myself.
  6. G

    Best Place to get Massey Parts for 240

    Known people that have had good luck with wiring harness from Agri-services. Untitled URL Link
  7. G

    Donkey help

    My neighbor and also family members have donkeys with cattle and none of them have had any problems. My cousin got 2 donkeys because of coyotes killing his calf’s , has not had any killed since.
  8. G

    4225 MASSEY FERGUSON TRACTOR

    My dad bought a 4243 about 15 years ago. Has probably 3,500 hours on it now. Been a good tractor, only repairs I remember doing on it other than maintenance is replacing both rubber brake lines and put a new seal in the front of the a/c compressor. Great engine and good on fuel for its size.
  9. G

    GM transmission cooling line

    That looks like the one that is supposed work, there are different sizes though. I’ve done a lot of those cooler lines and many times I take a small pick and remove the small retainer clip from the radiator. Them reinstall it once the line is removed. Be careful, the clip is very hard to find if...
  10. G

    M.f. 1150 and 1155

    I have 75 acres that I hobby farm, I have a MF 4243, and 2 283?s but the handiest tractor I have is a MF 235. The smaller tractor is so easy to get into tight spots, turns tight when raking hay and good on fuel. Wouldn?t trade it for anything.
  11. G

    NH knotter problems solved!

    I have a New Holland 315 square baler that has been missing 1 bale out of about 20 for a couple of years now. I have a accumulator which makes it a real pain. Made adjustments per manual several times which has helped but still would miss. Been using Redline twine and noticed some really poor...
  12. G

    MF 65 wiring harness

    I would try Agco-Services. They make tractor wiring harnesses. Untitled URL Link
  13. G

    n/h 848 round baler

    Haven?t looked at the wiring diagram but you could probably hook up power wires from a 2 way momentary toggle switch to the motor. Have to look for the manual to mine to make sure. Probably would take more power than a switch could handle and would have to have relays in the circuit.
  14. G

    New Holland 848 used parts

    Thanks to everyone that replied, found the used parts I needed at Fry?s and a airbag on fleabay.
  15. G

    New Holland 848 used parts

    I have a New Holland 848 round baler that I need to replace the airbag and a part they call the front upper apron support. The part # is 9827541 from New Holland. I have already tried All States Ag parts with no luck.I would like to try to find a used one if I could. The airbag I will probably...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top