(800) 853-2651
SHOP NOW

Recent content by George G Smith

Yesterday's Tractor Forums
  1. G

    How do you install a rear rim on a tractor JD-A

    I am pretty sure that you can work the wheel over the cast center by turning the wheel on an angle to the center. I have done it on an A John Deere.Greg.
  2. G

    O/T Something to Ponder....Electrical Question..Fun

    I had a electrical foreman at my place of work tell me if he could find enough solar collectors around a 100 watt bulb, He could run his house. He made a lot of money thinking like that. Greg.
  3. G

    wc oil preasure

    My speed patrol had no pressure when warm, I pulled the engine and the cam bearings were shot. Now I have pressure on the high side. Hope that helps. Greg
  4. G

    wd 45 pto

    Thanks, I've been thinking about it lately, with all the snow. Greg
  5. G

    wd 45 pto

    does anyone know if you can turn the pto gear box around to run a front mounted snow blower. Seam like it could be done. Thanks Greg.
  6. G

    B.F. Avery question

    My v was shortened too. The frame wasn't cut but the rear end was just slid forward. Greg PS I still don't know whether I should but back.
  7. G

    1985 olds v6 diesel in pickup?

    I had one in a 83 Celebrity, really liked the car. I always wanted to put one in a small tractor. It had 85 HP at 1600 rpm, Greg
  8. G

    ** One Room School House **

    There still 5 active one room schools in Huron County in the state of Michigan. Church School has been active for over 112 years. It is located on Church Road and is a public school. It presently has 28 students, one teacher, and two aids. I've been on the school board for 15 years. It is a...
  9. G

    Rare tractor ??? Small rant.

    I have the last ib allis chalmers built in 1950, Would that be rare?
  10. G

    pertronix electronic ignition

    I installed one in a 3cyl jd, It was firing between the posts on the distribter cap I had to install the point plate 180 degrees away from normal to get it to run.
  11. G

    Wisconsin engine TJD

    Tight valves will do that also,
  12. G

    Adapter Kit

    I have seen 4.3 chevy v6 engines in them, I think there is a kit for them.
  13. G

    1951 to30 pto seal

    I did an 8n, the spline was twisted in front of the pump and I had to cut the shaft and grind the spline to get it out. I hope that isnt what your proplem is. Greg
  14. G

    Pernell Roberts

    Thanks for the information. I'm looking forward to getting my DVD's Thanks again
  15. G

    Pernell Roberts

    Where did you get the whole series? All I found was season 7 and 8 on Amazon Germany. I already have enough of the seasons one thru six. And where would I purchase a multi play code free DVD player? I'm really interested in seasons 7 thru 13. I have a grandson I want to share them with him...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top