(800) 853-2651
SHOP NOW

Recent content by Gonya518

Yesterday's Tractor Forums
  1. G

    ford 2910 instrument cluster wiring

    hey everyone, I have a 2910 that has been sitting for a while. The instrument cluster was removed by someone previously. I purchased a new, assuming updated one and need to hook it up. I have no idea where each wire is supposed to go. please see pictures for reference and any information you can...
  2. G

    TE20 not starting no spark

    Jim thank you for the help. I have spark at the plugs now, cleaned and re-adjusted the points seemed to work. Still won’t start, gas not filling up the fuel bowl unless I loosen it. Gas to carb is there as it was starting to leak out of the drain screw.
  3. G

    TE20 not starting no spark

    Thank you Jim(s) for your reply. I have 12v at both sides of the coil with the key in the on position. Checked the points and cleaned for any coating and I have a spark there. Distributor is turning and have12 volts on the open points but when they are closed I have 0v.
  4. G

    TE20 not starting no spark

    Hello everyone, I have an issue with my '49 TE20 (I believe that's the year) starting. I have no spark to the plugs. I have checked the coil and it seems to test fine. .02 on the primary and 9.62 on the secondary. I also tried another coil with 10-11 on the secondary. I put a new condenser...
  5. G

    IH 504 Fluid leak

    Hello everyone. I have a question and am looking for insight. I have a IH 504 Gas that i recently got running again. i have 2 issues that i would like some help with. 1. I have a fuel leak coming from the carb so i need to shut off the fuel bowl every time i am not using it. What would be...
  6. G

    IH 504 Hydraulic spool

    Any idea on the easiest way to remove these pipes from the hydraulic housing. I have used a socket on the back but was only able to remove the cap on the back of the left one. I tried channel locks but didn't work. I briefly tried a pipe wrench but didn't want to put to much pressure in case I...
  7. G

    IH 504 Hydraulic spool

    Hello everyone, I am checking to see if anyone can give me a yes or no if I can safely pull the hydraulic spools(the ones that control the loader) on my IH 504 utility? They are located on the right side of the seat. One of them is leaking and I have new o-rings for them. I was thinking because...
  8. G

    IH 504 Gas - Not starting

    suggestions for engine oil and hy/tran oil?
  9. G

    IH 504 Gas - Not starting

    This looks like the spool that i have, but it is 2 spools in the same block. Would this be the same diagram. also how do i determine which o-rings i need as it give 2-3 for each?
  10. G

    IH 504 Gas - Not starting

    Thanks everyone for your input. Good news. Tractor runs fine. Took the governor to carb linkage off and shortened it 1/2 turn and that fixed the really high idle. Will probably need to rebuild the original carb in the future. So on to the next issue. I have a hydraulic leak coming from the back...
  11. G

    IH 504 Gas - Not starting

    Thank you everyone for the help. Update time..... After installing the new carb, fuel bowl, and new plugs. Idiot ahead....I didn't realize that the new carb had an adjustable jet on the bottom. So that being said, it was closed, that solves the fuel not getting to the plugs. However when I...
  12. G

    IH 504 Gas - Not starting

    Thank you everyone for the info. will check into the things mentioned. tried the above mentioned adding gas to the cylinders and it does start but dies right after that burns off. The tractor will turn over and start quickly the first time, almost like it has something in the Cylinders. usually...
  13. G

    IH 504 Gas - Not starting

    Spark plugs wires are in the correct order. will inspect the distributer and internals. tried with the gas in the cylinders(not much) but it did start
  14. G

    IH 504 Gas - Not starting

    wwoodrow: It is currently not running i have fuel in the carb and have spark at the plugs i guess i could check the timing but i have did nothing to mess with it, so assuming it is fine
  15. G

    IH 504 Gas - Not starting

See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top