Recent content by Herm00

  1. H

    1170 Alternator

    Just put a new alternator on my 1170. Now the alternator light comes on when I shut the key off. Any ideas?
  2. H

    Head Studs on CASE Crawler

    9/16 course on bottom, fine on top. I was able to come up with a full set. I ended up pulling some out of the massey 55 I had sittin here for parts.
  3. H

    Head Studs on CASE Crawler

    Im am putting my Crawler back together this weekend. While removing the head, I wrecked a few head studs. I was wondering if I could use bolts instead of studs? Or is that not recomended?
  4. H

    Head Studs on CASE Crawler

    Im am putting my Crawler back together this weekend. While removing the head, I wrecked a few head studs. I was wondering if I could use bolts instead of studs? Or is that not recomended?
  5. H

    Cylinder Sleeve O-Rings for 1000 Crawler

    Where is the best place to find O-Rings for the sleeves on my 1000 crawler?
  6. H

    Case 1000 Crawler Head

    Will the head off of a Massey Harris 55 work on my 1000 Crawler? They look the same with a few minor differances. Just want to make sure before I put it on the crawler.
  7. H

    Case 1000 Crawler Head

    Will the head off of a Massey Harris 55 work on my 1000 Crawler? They look the same with a few minor differances. Just want to make sure before I put it on the crawler.
  8. H

    55 Western Special

    What is different about a 55 Western Special than a regular 55? Are they more valuable? What is one worth, running but not restored?
  9. H

    Case 1000 Crawler

    It is a diesel. That makes sense that if it were stuck open that it would fall off next startup. I suspect a head gasket because it was leaking oil in the water. To finish the job i flushed radiator out and added oil and ran it like that a few times to get the project done. Then it went the...
  10. H

    1000c Crawler Motor

    Taking the motor apart on my 1000c crawler because I suspected a blown head gasket. I took the valve cover off and noticed the a push rod missing on and intake valve. It was down in the hole so it is probably broken. I aslo took the head bolts off to pull the head. We were unable to break the...
  11. H

    Case 1000 Crawler

    Taking the motor apart on my 1000c crawler because I suspected a blown head gasket. I took the valve cover off and noticed the a push rod missing on and intake valve. It was down in the hole so it is probably broken. I aslo took the head bolts off to pull the head. We were unable to break the...
  12. H

    700 Plow

    Looking at a 4-16 Model 700 plow. Are these plows any good? How do they handle corn stalks, plug or go through them pretty good?
  13. H

    1000 Crawler Oil in Water

    My crawler is getting oil in the water. When I bought the crawler I used it 3 or 4 times and never had any problems. Then it started leaking oil in the water. I thought it could be a broken oil cooler so I bypassed it to see if it was but it isnt that. I have ran it a dozen times in the past few...
  14. H

    970 Power Steering

    We have a 970 that is having steering troubles. It doesn't want to steer very good unless it is neerly wide open. All the other hydraulics work fine. The problem started after it sat for a winter. Any ideas on what the problem is and where to look?
  15. H

    70 Series Tachometer

    The tach in my 1170 doesn't work. Neither do the tachs in my dads 970 or 1070. Is it the tach itself or a cable or sensor problem? I would like to get mine going again.
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top