Recent content by Husband

  1. H

    IH 270A backhoe

    I just purchased a IH 270A backhoe for $2,200.00. I am looking for hydraulic ram seal kits for the IH 270A backhoe. 7 of the 9 rams leak. Can't seem to find a number on the rams. Not sure if these are IH rams or Digmor or another. IH sold to Dresser equip. than Dresser sold to Komatsu...
  2. H

    IH 270A Backhoe

    I tying to locate cylinder kits for a IH 270A backhoe. I can't find them or this Model backhoe on the IH website. I know IH construction sold to Dresser equipment and Dresser sold itself to Komatsu. thanks you
  3. H

    Ford 6710 Wiring

    I am trying to fix the wiring on my 6710 gauges. The wiring harness colors on the tractor do not match whats in the book. Its a England made tractor. Can any one help?
  4. H

    Case 930

    thank you!! I will give u call sometime today.
  5. H

    Case 930

    thank I'm in South Louisiana
  6. H

    Case 930

    I'm looking for some aftermarket 7.50 X 18 inch open center rims for a Case 930 Part #A27257. I found them on Messick but looing for a better price or used rims. Thank you William
  7. H

    vermeer belts

    I have a 605j baler , belts will not tighten add air up to a 100# as a test but no luck with tight belts. bled air down to 75#. Belts are all cut at 43'6 but need to be 44'. could something be frozen? thanks
  8. H

    Ford 5000 blows gasket

    The valve was stuck. I had to remove the rock shaft cover and replace the broken shaft. I will have to take the rock shaft cover off again because I pull on the select knob it was suck and so I pull harder and it came out. The remote was working when I purchase the tractor but not the 3 pt...
  9. H

    Ford 5000 blows gasket

    its has a lines for a remote cylinder
  10. H

    Ford 5000 blows gasket

    ok thanks I will check
  11. H

    Ford 5000 blows gasket

    The gasket blow out from the side pump where it bolts on. It pushes the gasket out and throwing oil towards the rear axle.
  12. H

    Ford 5000 blows gasket

    I have a ford 5000 that blow out the gasket on the side hydraulic gear assembly pump when a pull out the selector knob. I seems that pressure is building the transmission case where the filters are. Can any one help with this?
  13. H

    pto

    yes the spline are not line up, should they be? I might have to chisel the two apart. I don't see a washer between them
  14. H

    pto

    How do you remove the pto sleeve from the back gear on ford 6710. I removed the front gear but the back gear and the sleeve(hold the back bearing) will not fit thru the bottom hole. How do u separate the two pieces. Thank u William
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top