(800) 853-2651
SHOP NOW

Recent content by ihjason

Yesterday's Tractor Forums
  1. I

    H Farmalls--Show of hands...

    3 super hs for me. I have an ih 110 sickle mower I mow road ditches with all summer. Another has an arts way belly mower. Very handy tractors.
  2. I

    9N PTO problem

    I use my 9n on a brush mower. This summer the PTO lever became very difficult to engage and disengage. I was going to pull the PTO out the back and try and see what's going on. I suspect the splines are twisted on the front and won't pull through the pump. I can't get it to come out the back...
  3. I

    Farmall 450 Diesel - Gas Side Carburetor

    That wire is for grounding the magneto when switched to diesel. So it isn't continuing to have spark when running on diesel. The 450 diesel came factory with a distributor so that intake is probably off of a regular md. Still will work just have to remember to shut power off to coil when...
  4. I

    super w6 question.

    The mds frame rails have dents like that. I'm wondering if your super w6 was a super wd6 at one time.
  5. I

    IH 350 D I esrl fuel system

    I think the row crop 350 diesel holds 18 gallons. The utility version probably only holds 10.
  6. I

    WD6 Won't switch to diesel

    The rack is the threaded part at the top of the screen. It should move with the other two and doesn't look like it is.
  7. I

    WD6 Won't switch to diesel

    I agree with others. It's sounds like the rack is stuck in the pump. The fuel pressure gauge only gives a reading from the transfer pump. You could still have good pressure on the gauge with a rack that's stuck.
  8. I

    350D injection pump

    That's an interesting tach drive. Ive always seen them driven off the back of the generator. Does the tractor have hydraulics?
  9. I

    Sell it or Keep it

    I would definitely keep it. That looks like a nice tractor. If you did end up selling I know I'd be interested.
  10. I

    7710 series 2 not cranking

    Is there a safety switch that could be bad? Does the clutch have to be pushed in to start or in neutral?
  11. I

    Farmall 504 ta

    I'm working on a farmall 504. The ta pressure plate throw out bearing went out. I'm guessing it wasn't adjusted in years. I've worked on other tas. Normally when you get the engine pulled away you can pull the PTO and drive shaft out the front. On this one the it seems like the lower PTO gear...
  12. I

    Farmall super h alternator question

    Thanks for the replies. I will check again with a different meter.
  13. I

    Farmall super h alternator question

    I have a 10 si alternator on my super h. The gauge quit working last summer so I put a new one on today. Still doesn't show discharge or charging. I put a volt meter on the battery. The volt meter constantly shows different voltage. It changes numbers so fast I couldn't get a reading. Anyone...
  14. I

    1206 hitch problem

    Ive had a similar problem before. There is a draft control arm in the rear end that do to wear in linkages pops out of place. I took the top link holder off the rear end and could see it from there. It runs from the bottom of the rear end up to the 3 point cylinder.
  15. I

    Farmall H hood gasket?

    I have used weatherstripping cut to length before.
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top