(800) 853-2651
SHOP NOW

Recent content by jandsfarm

Yesterday's Tractor Forums
  1. J

    Repair Cat D3C

    Sorry CAT D3C is a 1998.
  2. J

    Repair Cat D3C

    Hi, I"m looking at a Cat D3C, unit will work in 1st gear but not in 2nd or 3rd. Any ideas on problem and cost to fix! Anybody had this problem? I know this is a hard question with out more info. Thanks for your time.
  3. J

    4430 Clutch Problem

    Thanks for your reply. I will look at the springs.
  4. J

    4430 Clutch Problem

    Jim, I guess my guestion was not clear. You should be able to slowly let the clutch out to inch the tractor forward. On my tractor when you let the clutch out it will grab!
  5. J

    4430 Clutch Problem

    Hi folks, I have a 77, 4430 that is a great tractor. Pulls good in all gears, runs excellent! My problem is the clutch, you can't slip the clutch. As you let the clutch out it will grab. Is this an adjustment or do I need to rebuild the clutch valve unit? The tractor has a Quad-Range trans...
  6. J

    Seasons Greetings A Pic. From Central NY

    Thanks, It's nice to see some local pix's. Looks the same over in Jordanville. Have a Happy New Year!
  7. J

    Some IH pics from summer...

    Hi, where in upstate is your club located? I'm close to Mohawk. Thanks.
  8. J

    Another Rip-Off!

    Take the time to look at this web site, stillmakeinusa.com thanks.
  9. J

    What John Deere combine!

    I’m new to the combine forum, but was hoping to get some advice! I want to find out what was the first John Deere combine to utilize true hydrostatic drive. I want to use an older JD unit to make into a snow blower. I did see that a 7700 was used in an article on the Farm Show web site. Has...
  10. J

    Charging Problem Farmall 200

    Thanks for all the input! I tested the generator by only connecting to the battery, the unit would turn. Also shorted terminal "F" to ground and checked the voltage on terminal "A" with the tactor running and got about 15 volts. All looked good until I took the generator apart, the wire that...
  11. J

    Charging Problem Farmall 200

    Thanks, my charge indicator is in the neg when the engine is running. I'm using a fluke 77 meter $140 in it's day.
  12. J

    Charging Problem Farmall 200

    I have charging problem on a 200 that I restored. A voltage reading taken at the battery constantly fluctuates to the point I can’t get a reading. I have checked the generator and the tractor has new wiring. The voltage regulator has been changed twice. Help! Thanks for your time!
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top