(800) 853-2651
SHOP NOW

Recent content by jcrane

Yesterday's Tractor Forums
  1. B

    identify john deere tractor

    saw this on craigs list,any idea of the model? bill
  2. J

    raking hay

    I have a 9 wheel rake and I rake every and all directions with absolutely no problems. I have also never paid attention to which way the hay was cut. you could drive yourself crazy with this idea! my advice would be to forget about it and rake your hay (however you wish) j crane
  3. J

    vermeer 605 super J

    I just purchased this baler and I do not have a manual yet. I am needing to bale about 100 bales or so (tomorrow!) This baler is new to me and I am looking for advice as to what pressure I should set my air at. I want to make about a 1200 lb bale. Is there any other tips / tricks I should...
  4. J

    hp and pto question

    thankyou for your considerations. It is sounding like this is too much baler for my tractor.
  5. J

    hp and pto question

    I am in need of some advice. I have an 830 case with a 540 pto. I am looking at a buying a vermeer 605J round baler. I have 2 questions. 1. I realize i am at the lower end of power for this baler...but can I make it work. Will I have enough power to run the baler and make 5" / 5.5 ft bale...
  6. J

    brakes are stuck - 730 case

    thank you for the good advice. the tractor is sitting outside. I am going to work on it this weekend
  7. J

    brakes are stuck - 730 case

    I have a 730 case and i had set the brake when I turned it off and then about 1 week later I went out to use the tractor again and the right brake won"t let go. It was and is about 20 degrees. I have tried to go both forward and reverse to try to "break it loose", and it is locked up solid. I...
  8. J

    730 case with 830 engine

    I posted this as well in the case forum, but thought I would post here as well. I am looking at a diesel 730 case with a 830 engine. loader and grapple included. there is about 500 hrs on an engine overhaul, new clutch, straight tin and new paint. $4500 I was looking for a tractor around 90...
  9. J

    806 international

    I am looking at an 806 international with a 320 loader for $6,000. What is your experience with this tractor? is there anything that I should be looking for or looking out for? I will be baling and handleing round bales and I will be using the loader for some light dirt work as well. I will...
  10. J

    loader for mf65

    i am looking for a loader for my MF65. I am concerned that it is too small for a loader, but I have seen many of them with laoders. Do any of you have experience with having a loader on this tractor? If so, what size loader should I be looking for. I was thinking a Dual 300, or Dual 325...
  11. J

    buying a case 1030

    Yes the tractor has a 3pt. and the cab is noisy. I think I will have to hang a pair of ear plugs in the cab.
  12. J

    buying a case 1030

    This morning I looked at and test drove a 1968 1030. It is a bigger feeling tractor than I was expecting. There was not as much room in the cab as I was expecting also. These were not bad surprises, just not what I was expecting. It was about 40 degrees this morning and it started up with...
  13. J

    willl a Du-al loader model 325 fit a Case 1030 w/cab

    I am looking at a Du-al loader model 325. Will this fit on a Case 1030 with a cab? I am not sure it the cab will be in the way or not. If this loader will not fit the 1030 then what type of loader should I be looking for?
  14. J

    1968 Case 1030

    Tires are about 60%. Yes is it a comfort king. Thankyou for the advice.
  15. J

    1968 Case 1030

    So I am looking to buy the 1030. Price is $3,500. It has not been used much for the past couple years. I will also have about $1200 into a loader. The owner says the clutch is good. Starts and runs good. He bought the tractor from a retired farmer a couple years ago and just has not used much...
See more
Yesterday's Tractor Forums
Buy Tractor Parts Here Buy Tractor Manuals Here

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Copyright © 1997-2025 Yesterday's Tractor Co.

All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.

Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy

Back
Top