-
J
David brown 1210 pto clutch?
Hello everyone I recently found a pice of bolt or something in my clutch housing I got it out but now the pto wont disengage so it must have something to do with thatit looks similar or pretty much the same as this bolt looking thing I have outlined here in the picture. Anyone have any suggestions?- JJUK
- Thread
- Replies: 1
- Forum: Case & David Brown
-
J
David brown 1210 thermostart fuel line
Hello I have a David brown 1210 and it’s missing the fuel line for the thermostart/glow plug I cannot find a replacement anywhere so I was thinking about making my own. Does anyone know the size of thread it is that goes into the adapter that comes from the fuel tank or I could even just put a...- JJUK
- Thread
- Replies: 1
- Forum: Case & David Brown
-
J
Jubilee rad
The rad currently on my jubilee has a non pressurized cap should I have a pressurized one or not? Or is that rad designed to be non pressurized. How do I tell? Thanks! -
J
Ford Jubilee End play
I put one shim behind the backing plate against the trumpet then put back the others on the retainer thats how they came off -
J
Ford Jubilee End play
Thanks for the reply! I dont think the hub is bad it looks good and its like slight bearing play it sounds like. I can hear the axle shaft inside the diff tapping when I rock the wheel -
J
Ford Jubilee End play
Hello all. So I recently replaced the left side pinion bearing and have put everything back together. Used all the same shims that came off. So now its all back together with wheels on and on the ground I can go up to the tire and grab it and it rocks back and forth and clinks inside. So I... -
J
Ford jubilee Lift cover o ring?
Do you know where I can find one of these? I dont see any online -
J
Ford jubilee Lift cover o ring?
Sorry no this little o ring looking thing. I cant seem to find anything on it or about it. As you can see mine is broken -
J
Ford jubilee Lift cover o ring?
Hi there does anyone know what this is called and how I can replace it. Shop manual doesnt cover it. Thanks! -
J
New govenor
Hello everyone. So I recently bought a new govenor and installed it but I am having trouble with it. So I also put new linkages from both throttle and then also the one for the carb. But when the tractor is running I move the throttle just a little and the tractor is way past full revs. Seems...- JJUK
- Thread
- Replies: 3
- Forum: Ford 9N, 2N & 8N
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
Yesterday's Tractors - Antique Tractor Headquarters
Website Accessibility Policy