Recent content by jmaul

  1. J

    Massey Ferguson Loader 235 Bucket Cylinder snap ring tab broken

    I have a MF 235 Loader with leaky cylinder. I want to replace the seals, but upon trying to take it apart, I realized that one of the tabs is broken on the snap ring. Any advice out there to get it out? The picture below, but you can see in this picture both tabs are visible, one of mine...
  2. J

    fuel line issue?

    Thanks Ill give that a try
  3. J

    fuel line issue?

    Thanks Ill try that
  4. J

    fuel line issue?

    Ive got a 1977 MF285 Diesel. I've repeated had an issue while using the tractor after awhile it all of a sudden will die and I've got air in the fuel line. I disconnected the main line to the lift pump and no fuel would flow until tapped the line and it would eventually flow again. The tank...
  5. J

    Power Steering line issue

    I was leaking fluid out of my power steering cylinder so I pulled it out to repair. While taking it out one of the fittings became damaged. Im not sure how to repair the line. The metal line ties into the braided hose in what I think is a compression fitting but it appears its been covered...
  6. D

    Rusty6 Puzzle

    I finished the puzzle tonight. Fun,but not too hard. The first jigsaw I've done in years.Thanks for posting. Steve
  7. rockyridgefarm

    Neighbor is building me a hay wagon

    We help each other out quite a bit, and really wanted to build me a hay wagon, so I got him the heat and materials. Ill probably have $1500 in it by the time it sees bales. The first pic is another neighbors wagon we sorta model it off of.
  8. J

    Ford 641 Carburetor issues?

    The guy I bought it from rebuilt it a few years ago, do you still think it's worth rebuilding again?
  9. J

    Ford 641 Carburetor issues?

    Should clarify, I had put new plugs in last March and these were very foul and full of carbon so I'm thinking it's getting too much gas and not burning efficiently.
  10. J

    Ford 641 Carburetor issues?

    Has a good spark, changed the plugs and started right up, still leaks gas, looks like I need to replace rebuild the carburator.
  11. J

    Ford 641 Carburetor issues?

    Does it matter that it drips even when I don't try to start it? It runs out if I don't shut the fuel line off, as soon as I open it it starts to drip again.
  12. J

    Ford 641 Carburetor issues?

    I've got a 641 that has run fairly well for the past couple of years, but now I can't get it to start and its got fuel dripping from the opening to the air cleaner. Any thoughts?
  13. J

    641 3 point arms lifting issue

    Nevermind, found it and no I don't have one
  14. J

    641 3 point arms lifting issue

    Nuday tool?
  15. J

    641 3 point arms lifting issue

    I've got a 1959 Ford 641 that the 3 point arms will only lift if I push down the draft control lever. I only have to push it for a second or two once the blade i have on starts to come up it works normally, unless I lower it back down to a couple inches off the ground then in falls all the way...
Yesterday's Tractor Forums

We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today.

Back
Top